No hay artículos en el carro
No hay artículos en el carroAustin G.
Comentado en los Estados Unidos el 18 de julio de 2022
Collet fits too loose into the nut
James White
Comentado en los Estados Unidos el 13 de junio de 2020
The runout on it is not bad. The edges were polished to the point that they are slightly rounded off. The retension spring is unable to hold the collet in the cap. The collet gets stuck in the body of the chuck and has to be pried out.
eric buchanan
Comentado en los Estados Unidos el 2 de enero de 2020
Project wasn't bad but it needed instructions other than that was a good product would recommend
Brian W.
Comentado en los Estados Unidos el 12 de julio de 2019
Perfect just as ordered
PP
Comentado en los Estados Unidos el 28 de mayo de 2019
Run-out at collet edge is over 0.005", and 2" away, it is 0.012". I was planning to use it to hold an electronic edge finder, but it is unusable for that purpose (or any purpose on a mill really). Looking at it a bit more closely, I note an 1/2"x ~100 degrees area of quite rough interior surface, about 1/4" from the edge. There's also an aborted slot cut on the back end.Sheesh!
Productos recomendados
Mex $847.70
Mex $ 440 .00 Mex $440.00
Mex $256.00
Mex $ 140 .00 Mex $140.00
Mex $1,500.95
Mex $ 615 .00 Mex $615.00
Mex $1,773.42
Mex $ 851 .00 Mex $851.00
Mex $373.00
Mex $ 175 .00 Mex $175.00
Mex $403.22
Mex $ 217 .00 Mex $217.00
Mex $3,012.36
Mex $ 1,476 .00 Mex $1,476.00
Mex $346.00
Mex $ 155 .00 Mex $155.00