No hay artículos en el carro
No hay artículos en el carro
Este producto es solo un sustituto de tu equipo. Conecta la horquilla roja al polo positivo "+"y el azul al polo negativo"-".
Si el artículo que has recibido es defectuoso o recibe algún otro problema de alguna manera, por favor envíanos un mensaje gratis para obtener ayuda o reemplazo o reembolso gratis sin devolución.
Allan E.
Comentado en Canadá el 27 de noviembre de 2024
I have now used these sensors in several different setups at temperature settings ranging roughly from room temp up to 400F or so. They have performed exactly as intended, and all continue to function perfectly after several years. If you need sensors of this basic design, these will do the job very well in my experience. Highly recommended.
Customer
Comentado en Canadá el 14 de noviembre de 2023
Old units were getting beat up in the hostile environment, needed reliability.
Mr Shopper
Comentado en los Estados Unidos el 11 de julio de 2021
Great quality
Kevin Jackson
Comentado en los Estados Unidos el 4 de mayo de 2021
The threadded section is not one piece, and does not create an air seal. Would probably work just fine on an plenum system, but I purchased them to screw into a water pipe. After using a bit of epoxy I was able to seal the inner free piece to the outer screwed piece and was able to get it water tight to 30 psig.Actually, if I used it for an air plenum, the free inner piece keeps you from tangling the wire when tightening, which is a nice feature. I hooked to a K type PLC module input, and it reads just fine.
Billy E. Pickell, Jr.
Comentado en los Estados Unidos el 15 de noviembre de 2021
These work well with my Inkbird temperature controller.
Productos recomendados