No hay artículos en el carro
No hay artículos en el carroMás información del producto
Impresora de red
Permita el soporte de impresión entre varios equipos conectados a la red, maximizando la funcionalidad de las impresoras existentes. El adaptador de servidor de impresión admite velocidades Ethernet de 10 y 100 Mbps con negociación automática.
Coloque la impresora en cualquier lugar compartido conveniente que permita a varios usuarios acceder a los servicios de impresión sin demoras.
Conecte una impresora paralela
Este servidor de impresión Ethernet compacto se conecta directamente al puerto Centronics de la impresora para obtener una solución de red segura y discreta. Para configurar y agregar la impresora a la red, utilice la interfaz web desde cualquier sistema operativo o el asistente de instalación basado en Windows. El servidor de impresión también admite IPX, TCP/IP (LPR, IPP, RAW 9100), NetBEUI, AppleTalk, SNMP v1 y 2, SMB.
Steven Mims
Comentado en los Estados Unidos el 26 de marzo de 2025
Great for when those Parallel printers need an IP address!Easy enough to configure, then put into place. The ones I've used have been up and working for at least 5 years now.
Used_to_be_a_Sony_Fan
Comentado en los Estados Unidos el 10 de febrero de 2025
The ethernet to parallel print server completely restored my wide-carriage MX-100 from ballast to a printer useful for software debug. It worked the first time and the Window 10 driver was already installed although the driver was labeled as an IBM wide-carriage printer. The dot matrix graphics were also supported by the printer server and the Microsoft driver.
Anabel Villarreal
Comentado en los Estados Unidos el 7 de abril de 2025
Funciona a la perfección
Gregory Wirtel
Comentado en los Estados Unidos el 5 de abril de 2025
Garbage. Installing the software corrupted my Dell laser printer software and it took hours to get everything back. After ask that, while it did show up on my network, I could never print to it.
ADP IT Department
Comentado en los Estados Unidos el 10 de octubre de 2024
This adapter was able to turn our Zebra ZP450 UPS Label printers into network printers and we couldn't be happier with the results. Since Zebra does not even have a factory option for a network card on the 450, we are limited to USB, Parallel, or Serial. When you have an entire warehouse full of computers all trying to ship material, the absence of the 450's networking really start to show. Of course, you can connect the printer to one computer over USB and then share it out over Windows, but what happens when that computer is offline? What about when it gets shutdown accidentally? Or even when it's time to replace it? This adapter eliminates all of those concerns.The first step is just to power on the adapter (not connected to the printer) and connect an ethernet cable from it to your computer. On Windows, go to control panel and change your ethernet adapter's IPv4 address to 192.168.0.15 and subnet 255.255.255.0. Navigate to 192.168.0.10 in your web browser and the adapter/print server should show up right away. From within here, you can change the IP Address, DNS name, and other settings. I would recommend changing everything else besides the IP, and then doing that last. Once you have it all set, connect the adapter to your printer, power it back on, and try to connect to it over the network. If you're successful, the only step left is to install the printer like any network printer except for the changing the protocol to LPR. StarTech has some fantastic documentation on all of this, so make sure that check that out too.
Productos recomendados
Mex $1,276.00
Mex $ 586 .00 Mex $586.00
Mex $1,031.00
Mex $ 494 .00 Mex $494.00