Juan Esteban Osorio Lopez
Comentado en los Estados Unidos el 31 de marzo de 2025
Excelente soporte para Atem Mini Pro y ISO, Buen material, resistente y práctico para sostener nuestra switcher y un monitor de campo delgado.
Signus
Comentado en los Estados Unidos el 2 de enero de 2025
The "SplashNColor Combo Stand for Blackmagic ATEM Mini Pro and ISO Series – LCD Monitor Stand for Thin Monitors – Stable Setup with Cable Management for Streaming Broadcasting Video Production" was a disappointment to say the least.I don't like writing one-star reviews for a product. Occasionally, I receive one that simply isn't ready for sale, could be dangerous, or damage something else I own by using it. I wrote this out of respect for those of you considering getting one of these stands for your video switcher so you know PRECISELY what you are getting.For starters, the feet were not fastened with sticky tape on the bottom where they belong even though the tape was on the feet themselves. Three were stuck on the accessory arm on one of the 3D printed brackets. One is missing... MIA.The 3D print is not good- can't fasten the feet on the dimples at all because the print is sub-par. Nowhere on the listing does it state this is a 3D printed product. For the amount they want for the two badly printed brackets, I could have purchased a quality filament and printed one out with a much better design.It's a tight fit- almost too tight. I'm not comfortable squeezing my expensive ATEM mini pro on the brackets. I did it for the photos, but not going to do that again. There is no way to adjust the fit, no cushion for the switcher... and it doesn't fold up for travel.Between the product being 3D printed (and not a good print at that), the too-tight fit, and feet that are not workable (and one missing), along with "extras" that don't particularly make much sense, this is a deal-breaker for me and not worthy of even 2 stars.My recommendation is to get an aluminum stand or at least one that doesn't pinch the video switcher.
JAC
Comentado en los Estados Unidos el 1 de enero de 2025
I am 99.5% sure this item is 3-D printed. I'm not saying that this is a bad thing, because it is finished very well. I don't have an ATEM but do not doubt that this will fit one precisely. I am using it to prop up my audio interface which it does nicely.It comes with 4 wood screws if you decide that you prefer to anchor it down. It also comes with two large foam double sticky sided pads if you decide you would rather keep it less permanent, whicch is the option I am utilizing.