No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Módulo controlador de carga de batería de litio de 3,2 V 3,7 V, placa controladora solar, módulo controlador de panel solar para 6V 12V
CONVENIENTE: El controlador de placa de circuito solar práctico. Carga durante el día y enciende las luces automáticamente por la noche sin intervención humana.
MULTI: módulo de control de carga de batería equipado sobredescarga y sobredescarga para que no tenga que agregarle una placa protectora.
PEQUEÑO VOLUMEN: La placa del circuito de control de la batería de litio está controlada por un solo chip para lograr un volumen pequeño multifunción, lo que puede brindarle más comodidad.
amateur hobbyist
Comentado en los Estados Unidos el 12 de diciembre de 2024
There appears to be 3 jumpers... not clear on what each jumper or combination of jumpers do. I assume to set the battery charge voltage or operation mode?
Michael Smith
Comentado en los Estados Unidos el 23 de septiembre de 2024
I used this as a small charge controller for a meshtastic node. Works very well, no problems so far.
TM
Comentado en los Estados Unidos el 25 de noviembre de 2023
I might be wrong but it looks like this is the same type of board that are used in larger Lifepo4 batteries. It's a basic setup but works. Anybody who is looking to build a no-frills charging setup will like this. I am using this on a wind wheel that produces power for the backup power unit. Five stars from me. I hope this helps to make a decision.
Steve in FL
Comentado en los Estados Unidos el 11 de noviembre de 2023
The battery used was a 3.2 volt LifePO4 lithium iron phosphate 1000 mah version (max. charge voltage of 3.65v), purchased through Amazon. The (subject) Lithium charging controllers’ directions are: 1st connect the battery, LED, and finally the solar panel. The controller will then “identify” what voltage and type of battery is connected by the no. of flashes from on-board LED, there were 2 flashes, indicating a 3.7v lithium battery (wrong). Knowing a 3.2v battery was connected I provided the “S2” jumper required for that battery voltage. The battery charged to 3.5volts, then charge current cutoff (note: 3.65v is safe limit). The solar charging and on/off control operated as expected. The battery ID and charging inconsistencies described may be my misinterpretation of the directions as difficult to understand. Another question is, what required jumpers, if any, are required if 3.7v, 6v, or 12v battery is “identified. ”There are not any obvious "procedures"/instructions for those battery voltages!?
ALAN NOEL
Comentado en los Estados Unidos el 1 de abril de 2023
Could use better instructions but when everything is soldered it works great
Productos recomendados
Mex $422.00
Mex $ 202 .00 Mex $202.00
Mex $548.00
Mex $ 295 .00 Mex $295.00