No hay artículos en el carro
No hay artículos en el carroDescripción del producto grex 23 Gauge pins 2" Headless – 2.5 K Caja From the Manufacturer GREX 23 Gauge 2" Length Headless Pins, 2.5M/Box. For use in GREX Model # P650.
darrell sikes
Comentado en los Estados Unidos el 3 de diciembre de 2024
No jams on my pin nail gun down to the last pin.
Matt W
Comentado en los Estados Unidos el 26 de enero de 2024
no jambs - perfect function.
Rick Gural
Comentado en los Estados Unidos el 31 de diciembre de 2023
they work great
Chris C.
Comentado en los Estados Unidos el 10 de enero de 2019
Great pin nails but broken up container due to bad packaging and no protection from other heavy products banging around breaking the pin nail container.
BigJimAK
Comentado en los Estados Unidos el 9 de abril de 2010
I recently picked up the P650L after having the PC 23ga pinner (1/2" to 1") for about 6 months for my woodworking. I was a bit of a skeptic at first that headless pins could provide holding power but so many friends on [...] raved about them for joining wooden pieces together, I decided to give it a shot. What I learned was that by angling the pins relative to each other the shear force of the pins holds them together, rather than the friction of the wood on the pin. I found them very useful for everything from holding trim pieces on table edges while glue dried to holding a piece of wood to a scarificial scrap while routing but found the 1/2" to 1" length somewhat limiting. Enter the P645L, capable of 1/2" to 2" pins (and 3/8" pins if you use a rubber band to temporarily override their "low pin" sensor.After receiving the Grex pinner and pins I decided to start with the ultimate test, loaded it with 2" pins, set the air for 100 psi and stacked up 5 pieces of scrap hard maple, about 1/2" thick apiece. The pinner drove the pins fully into the stack of maple with the head of the pin perfectly seated just barely below the surface of the wood. Two more pins at varying angles and, without glue, it still took me a chisel and a lot of force to get them apart. I give these pins and pinners two thumbs up... more if I had them! By the way, with the wide range of pins this supports, I've found having 2 pinners convenient.When practicing my dovetailing by building some shop drawers I tried driving a 1-3/8" pin through each end of the joint (and several pins), it instantly hard-locked the drawers; no Bessey's needed! Another couple of strategically placed pins (shorter, other pinner) immobilized the shelf while allowing for humidity-based wood expansion. The good thing was that, like pocket holes, there was no waiting for glue to dry. The advantage is the 23 ga pin holes are nearly invisible.
Productos recomendados
Mex $951.53
Mex $ 437 .00 Mex $437.00
Mex $1,187.59
Mex $ 593 .00 Mex $593.00
Mex $332.92
Mex $ 156 .00 Mex $156.00
Mex $430.07
Mex $ 215 .00 Mex $215.00