No hay artículos en el carro
No hay artículos en el carroJuego de brocas para construcción de puertas de 3 piezas
D. Robert
Comentado en los Estados Unidos el 9 de diciembre de 2024
These bits worked perfectly! They are super sharp and cut so clean that there was almost no sanding required. I'm very happy with this purchase. Our new interior doors turned out beautiful!!
SJ
Comentado en los Estados Unidos el 15 de diciembre de 2024
Works well
Mitch Leonard
Comentado en Canadá el 14 de noviembre de 2018
Obviously these things rock. Freud makes quality products. Very precise. Comes in cheap plastic. This is really about the router bits
Natalie Pilkey
Comentado en los Estados Unidos el 13 de septiembre de 2015
I tried using these bits with my Bosch router table that I bought from Menards. I could probably produce some low quality crown, but I was looking for as close to perfect at possible. I converted some old cabinets to a rolling router table and took all the parts off my Bosch table and produced an 8 foot table so I have plenty of infeed and outfeed. I also built a 9 inch fence with 5 featherboards to stabalize the boards as I run them through my process. I also adhered to freuds instructions which I found very helpful. I think the biggest issue is simply accepting the fact that you need a lengthy infeed and outfeed if you want flawless crown. I do not have to trim ends, it is perfect from end to end. I prefer 4 passes vs 3 passes. I mostly use MDO so I have very consistent results. The cost to produce enough trim for a room is so low. However, I've invested alot of time into my process. I measure everything in 32nds to maintain my quality and only use boards that are exactly 5 1/2 inches, else results are poor. I posted some pics if my results after sanding the line that is produced after routing the upper-profile. I only use Freud bits... Amazing products. I can produce higher quality than anything found in a store... I take pride in the process, it is a highly satisfying addiction:)
Isaac Moore
Comentado en los Estados Unidos el 25 de marzo de 2011
I used these bits to route a profile on a 5" high square base frame for a rotating bookshelf. I started with planed stock in both width and thickness. It was imperative to have stock that was the same width to allow the profiles to line up once the ends were mitred. Before each pass, I adjusted the fence and feather boards. It was very important to use double feather boards on the table and to have two f/b's attached to the table's fence. With this setup, I only had to push the boards from the end...no hand support around the bit. The finished product was very good. I had minor areas where the two bits left a line, but it was easily sanded out, even though I was using curly maple. I did get a little chatter 3-4" on the ends of the boards, but these were offcut when mitreing.BTW, Woodcraft has examples of routed profiles in their stores under the display. That is how I decided on which bit set to choose. Happy routing.
Productos recomendados
Mex $769.54
Mex $ 377 .00 Mex $377.00
Mex $377.59
Mex $ 177 .00 Mex $177.00
Mex $742.69
Mex $ 363 .00 Mex $363.00