No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Robert
Comentado en Australia el 30 de marzo de 2022
covered up the vent holes in the top of my case nicely
Don Cobblerone
Comentado en los Estados Unidos el 23 de diciembre de 2020
My fan is 120 MM, I only stand it and point it at my cable modem which gets really hot. But using the screws is impossible. Came to discover all I had to do is hold it up to the frame of the fan and the airflow holds it tight. Not being screwed down, I can just pop it off, rinse it, shake it dry, put it back. Can't beat it!
Joe D.
Comentado en los Estados Unidos el 26 de agosto de 2019
The outer part of he filter is hard enough to protect from most accidents like dropping screw drivers or heavier things on them. Un unlikely situation if you set it and forget it, put it happens. The soft spongy part of it is definitely going to filter most dust, but when it comes times to clean them it is gong to be hard to get them out. I'm afraid I may break the outer part trying to remove them.
Chris
Comentado en los Estados Unidos el 3 de marzo de 2017
I made a router and modem box (out of a letter sized decorative box from Amazon) to keep them hidden but they had a tendency to overheat. I installed this fan to the bottom of the box blowing downward so it would pull air through the back of the box where the cords come in. Couple with small feet to elevate the box a little, this fan keeps everything cool and running well while being virtually silent. You have to be right beside the box (ear inches from the fan) whenever is turned on or off in order to hear if it's running!
Skip
Comentado en los Estados Unidos el 25 de febrero de 2016
Ordered these filters to attack to a set of 120mm fans I purchased to cool down my Onkyo TX-SR805 receiver, which gets a little warm at times. The fans work great but I wanted to put some kind of filter on them to catch any dust. When these filters arrived, I thought they would work out so I attached them to the fans. However, with the filters in the holders, the airflow through the fan was significantly reduced. I then too the filter material out of the holder and placed it on top of the fan. The flow was reduced a bit, but not to the level it was when the filter material and grill holder was attached.The filter media is fine for catching the dust but when placed in the holder, the grill/holder restricts the airflow so much that I decided to use the media without the grill.These are fans designed for cooling a computer enclosure so the flow through them may not be as great as some other fans available. However, I did check around before buying the fans and found that they produced about the same airflow as most other fans in this size.I may try to cut out the rings in the grill to see if that helps increase the airflow as I would have liked to use the grills on the fans themselves rather than just the media. If this helps I will update this post.
Productos recomendados
Mex $914.73
Mex $ 493 .00 Mex $493.00
Mex $414.31
Mex $ 198 .00 Mex $198.00