Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

Alinear carburo, superficie de alerón CNC, broca para aplanar losa, 4 alas, 5 cm de diámetro de corte, vástago de 1/2 pulgadas, router CNC Pro-Series.

Envío gratis en pedidos superiores a Mex $600.00

Mex $542.42

Mex $ 282 .00 Mex $282.00

En stock

Acerca de este artículo

  • Crea una superficie lisa perfectamente plana con esta broca de fresadora de grado industrial, con punta de carburo.
  • ➤ Spoilboard CNC de 4 alas, punta de superficie, perfecto para mesas de enrutador CNC, enrutadores portátiles de mano montados en mesa.
  • Perfecto para madera, madera contrachapada, MDF y otros compuestos de madera, plásticos.
  • Diámetro de corte de 5 cm, vástago de 1,27 cm.



Descripción del producto

Planificador de superficie de spoilboard CNC router spoil board
spoilboard superficie router 1/2 pulgada CNC spoil board cepillado
spoilboard cepillado superficie 1/2 pulgada CNC router spoilboard

Douglas
Comentado en los Estados Unidos el 15 de octubre de 2023
Seems to be good quality. Quick delivery. Only used it once but worked great. Time will tell.
Jdib
Comentado en los Estados Unidos el 21 de agosto de 2022
I've been running this in my DeWalt router to flatten a slab of live edge cherry started out at 10 quarters and took it down to 6 quarters then did the epoxy then flattened again, I took it easy and only did an ⅛ in. At a time . I bought 2 bits due to what some people have said about it dulls out and burns the wood, needless to say I am still on the first bit, its holding up strong my next projects is black walnut , and ash , I hope I have the same results. If not I will update.
Brad Z.
Comentado en los Estados Unidos el 3 de junio de 2022
I purchased this bit to flatten out some smallish walnut slabs. I don't have a cnc, so I used it in my Milwaukee plunge router with a shop-built sled.My results couldn't have been any better! The bit left a perfectly smooth finish with no scorching and virtually no swirl patterns.I'm not sure about the longevity of the bit - I don't do much slab work. But the cutters are sharp and even, so as long as you don't drop it straight onto concrete and booger up the carbide, I don't see any reason this bit wouldn't last.Absolutely would recommend and purchase again if needed.
Mike Shaffer
Comentado en los Estados Unidos el 15 de diciembre de 2022
Worked awesome.. Great price. Fast shipping. And it held up great. I recommend.
Chad
Comentado en los Estados Unidos el 30 de septiembre de 2022
Bought this for use in my router for flattening slab material in my homemade plaining sled. It did a great job flattening walnut slabs. Just run your router at a little over half speed. I'm using a 2 1/4 horse router. There was no chip out and cuts were very smooth. Works great and much cheaper than a lot of the bits out there
Productos recomendados

Mex $567.06

Mex $ 260 .00 Mex $260.00

5.0
Elegir