No hay artículos en el carro
No hay artículos en el carroDescripción del producto
upHere - Cables divisores ARGB de 1 a 4 de 5 V y 3 pines
Tus accesorios ideales para computadora permitiendo que tus ventiladores ARGB y barras de luz se conecten suavemente al host que a través de un solo cabezal RGB de placa base, ofreciendo capacidad de expansión y flexibilidad necesaria para construir sistemas de iluminación estéticamente hermosos. Con cabezal RGB estándar de 3 pines que también es capaz de conectar el cabezal de 3 pines sin adaptadores adicionales. Utiliza material de PVC suave para facilitar el diseño en una carcasa estrecha. El diseño del 1 a 4 El cable del cable del cable del del para ahorrar espacio y conectar con otros productos.
Nota:
Ten en cuenta que solo se admiten encabezados ARGB de 3 pines para abordar tiras de iluminación LED RGB o ventiladores. No conecte un ventilador RGB direccionable (ARGB/Digital RGB 5V) a un cabezal de placa base RGB (estándar de 12 V) o driver RGB.
EhmTeeEhf
Comentado en Canadá el 28 de marzo de 2025
Worked perfect for what I needed. thank you for including enough male adapters. It was just enough :)-
Sean Bobbie
Comentado en Canadá el 2 de abril de 2025
Installed these a couple years ago now and they're still holding up just fine. Does what it's supposed to do so I recommend if needed.
AllThingsTech
Comentado en los Estados Unidos el 4 de abril de 2025
I used this because my Asus B550-F Gaming Wi-Fi II motherboard has only 1x aRGB (5V) port. It has 2x 12v RGB ports which... I'm not quite sure why. That was older tech being phased out of products when the board was introduced.I am using this on a THERMALRIGHT Aqua Elite 360 V3 to hook 3 aRGB fans and 1 aRGB pump to my mobo's aRGB port. Zero issues.I believe 4x aRGB devices are the limit for a single port, so this worked out perfectly well. There is aRGB Gen 1 and Gen 2, so it may have been speaking about one or the other, not sure, but luckily that's all I have in my case now that is aRGB. I have Arctic P14's in the front (2x) and 1x in the rear and they don't have lights. With this board, if I wanted to go FULL lights for the other 3x fans, which would entail replacing them with aRGB fans, I'd need an aRGB hub controller.Not too concerned, honestly, I bought the AIO for the performance, which happened to have aRGB lighting so I wanted to make it work and this splitter handled that job flawlessly.Great product.
Mark A. Robertson
Comentado en los Estados Unidos el 5 de junio de 2024
Nice and small not adding that much clutter to my system. Thanks
Jim Parsons
Comentado en los Estados Unidos el 13 de marzo de 2024
If you know what this is you'll understand the value. You can't control the individual strands but in all likelihood, you're going to use the same settings for each anyway. It's thin enough to tuck away behind the motherboard for cable management. The connection cable is long enough to connect to the motherboard headers without exposing the additional cables. I connected this to an ARGB hub so the length wasn't an issue for me.
Productos recomendados
Mex $329.76
Mex $ 181 .00 Mex $181.00
Mex $595.47
Mex $ 315 .00 Mex $315.00
Mex $780.48
Mex $ 413 .00 Mex $413.00