No hay artículos en el carro
No hay artículos en el carro
Especificaciones:
Condición: 100% nuevo
Tipo de artículo: asa de liberación de cierre de asiento plegable trasero.
Material: plástico.
Color: gris.
Reemplaza: 75220,7290908011,7290908011C0,7290908011B2
Garantía: 1 año
El paquete incluye:
1 manija trasera del asiento del conductor o del pasajero.
Compatibilidad:
- 11-20 Toyota Sienna-3rd Row (izquierda)
- 11-20 Toyota Sienna-3rd Row (Derecha)
☛ Comprueba el ajuste antes de realizar el pedido.
Asegúrate de que tu vehículo coincida con la descripción del ajuste.
JMCouchPotato
Comentado en los Estados Unidos el 27 de febrero de 2025
Fits perfectly, easy to install.
M. Young
Comentado en los Estados Unidos el 3 de enero de 2025
It was a perfect replacement for the original Toyota part that failed. Toyota did not do a good job of designing the latch but this replacement was easy to install and got the seat working again.Two suggestions for installation:1) It can be difficult to get the cable to fully snap into the latch. Push firmly and then pull on it to make sure it doesn't pop out again.2) Make sure the cable doesn't get stuck between the metal plate and the latch or the latch will not go back in correctly. I had to twist one cable into a loop and tuck it behind the metal. Then the latch went back into place.
Gina Ramirez
Comentado en México el 3 de junio de 2024
El producto llegó a tiempo, a pesar de no ser original tiene buen terminado y es muy similar al original, la diferencia es un poco la textura. Pedí el de color gris y estoy muy satisfecho con el tono. Envío fotos del producto antes y después de instalarlo. Lo recomiendo ampliamente.
Roy
Comentado en Canadá el 5 de diciembre de 2024
Easy installation and it works as it should be.
NA
Comentado en los Estados Unidos el 8 de septiembre de 2024
It took about 5 minutes to install.Pop the cap off with a flathead screwdriver.Then using a Phillips head screwdriver unscrew only 2 screws.Adjust the 2 wires in their correct sides. The wire on the left attaches to the left side of the handle, right wire with right side.Push the handle in to it's spot.Screw in.Push the cover back in place.So easy.Exact toyota quality.Perfect fit.Low price.
JOAQUIN G.
Comentado en México el 2 de mayo de 2023
Animate si lo requieres, es igual al original
Mark Ordeman
Comentado en Canadá el 5 de noviembre de 2023
The product was almost identical to the original Toyota part. Was easy to install. Works well
Antonio
Comentado en México el 9 de octubre de 2023
Muy buen producto, similare al original
Anna Helena
Comentado en México el 10 de octubre de 2023
Excelente producto ! Muy buena calidad , justo lo que necesitaba .
Productos recomendados