No hay artículos en el carro
No hay artículos en el carroCaracterísticas: 100% nuevo Voltaje: DC 5V Corriente de salida: 300mA 3 Alambre Polaridad: NPN Distancia de detección: 8 mm Estado de salida: normalmente abierto Número de pieza: LJ18A3-8-Z/BX Objetos de detección: Conductor El paquete incluye: 10PCS M18 8mm detección DC 5V NPN NO LJ18A3-8-Z/5V V V V cilindro cilindro de interruptor de sensor de proximidad inductivo voltaje de trabajo 5VDC especial para MCU
RVZ
Comentado en los Estados Unidos el 6 de febrero de 2024
Printer bed leveling is now actually fun to watch, rather than the tedious chore it was when doing it manually.
K. Bell
Comentado en los Estados Unidos el 8 de agosto de 2023
IF your 3D Print bed is ALUMINUM, and it is covered with a GLASS SHEET thicker than 3MM?FORGET about using this sensor. Yes! It will detect STEEL at 8mm but ALUMINUM detection is less than 4mm.DESCRIPTION should clarify detection distances for various METALS.VERY DISAPPOINTED!
KMD
Comentado en los Estados Unidos el 17 de mayo de 2022
The cable is too short for Ender 3 sized printers
Eddie Sheffield
Comentado en los Estados Unidos el 6 de mayo de 2019
I've been rebuilding a Printrbot Jr metal 3d printer that was given to me with a bad motherboard. I replaced the board with a MKS Gen L. The only problem was the board is incompatible with the original Z-axis sensor (6-36v, PNP, 4mm). I needed a 5v NPN. After a few failed attempts to adapt the original using some circuits I found, I ordered this one. I also wanted a greater sensing distance as the old one would not work with the addition of a heated glass bed.This one was plug-and-play electrically - just make sure and get the right wires to the right pins and configure the firmware. No extra circuitry required. The only problem I had, and this was purely caused by me not paying attention, is that this sensor has a substantially larger diameter than the original (M18 vs M12) so I had to do a bit of rework on the mounting. But once that was done, it works great! Something to keep in mind tho if you're changing sensors like I was.
Customer
Comentado en los Estados Unidos el 24 de octubre de 2019
Works great as a homing / bed leveling sensor for my ender 3 pro 3D printer. Tied right into the 5 volt supply. I’ve designed a sturdy mount for this you can print. Find it on tinkercad or thingiverse, search for “Ender 3 Leveling M18 Inductive Sensor Bracket”
Productos recomendados
Mex $292.00
Mex $ 151 .00 Mex $151.00
Mex $273.55
Mex $ 142 .00 Mex $142.00
Mex $389.00
Mex $ 194 .00 Mex $194.00
Mex $543.58
Mex $ 298 .00 Mex $298.00
Mex $214.22
Mex $ 126 .00 Mex $126.00