No hay artículos en el carro
No hay artículos en el carroDescripción del producto
SPEEDWOW - Tanque de lata de captura de aceite
Edward Martinez German
Comentado en los Estados Unidos el 26 de agosto de 2024
I would buy from this seller again. The product is just as described and excellent quality, Above all the good operation.
abdulrhman
Comentado en Arabia Saudita el 28 de junio de 2023
توصيل سريع وتغليف رائع شكراً
The Clarke’s
Comentado en los Estados Unidos el 19 de noviembre de 2023
ADDED UPDATE: LOOKING AT ADD’l PICTURES(especially the Red can) that Customers have sent in, I’M CONCERNED SOME CANS MIGHT BE INSTALLED BACKWARDS BECAUSE OF MISS LABELING. NO MATTER WHAT THE “WORDS” OR “ARROWS” SHOW, THE “IN PORT” HAS THE DIP STICK. AND THE “OUT PORT” HAS THE BRASS FILTER(the air enters the Can, THEN exits thru the Brass Micron Filter).I have a 2019 Outback. 1st pic is a Before pic. Next I have taken off the PCV Hose (Save Hose,Store with spare Tire so it won't be lost), exposing the Air Intake port and the PCV Valve directly below. Last pic is my final install. The most time spent was on fashioning the Aluminum L bracket supplied for install. With a Torch and 5lb hammer, I put two 90 degree bends and twisted the last 3" to 45 degrees to aim Can towardsports more directly. The can is nicely elevated so I can easily reach to unscrew the bottom of Can to empty. When connecting the ports to the Can (I used the 8mm), be sure to put the O rings on. And DON'T over tighten. Look to be sure the O ring is pressed firmly against Can, but NOT distorted and sticking out. It happened to me my first attempt actually. I backed it off and noticed the O ring went back under theFlange, hidden as it should be. I wanted to be certain there would be a good seal, so I backed both Ports out and added additional turns of Teflon tape(Supplied). I would say I put on 5 complete turns of T tape overall. Be sure tape is not covering the threaded opening. I set my fingernail lightly on the Tape at the beginning of the thread. Applying only enough pressure to "indent" the tape into threads, and not cut it. This will make it easier to "seat" the thread, and screw it in BY HAND AT FIRST. Now the port will feel more snug as you screw it to it's base. Only 1 Negative comment about product. The "In" and "Out" Ports are marked correctly with those words. Next to the Words are Arrows(Triangles), that face the WRONG Way! Annoying, but not worth returning it. I simply took a Black Sharpie and Blotted out both Triangles. I read Mfr had fixed this issue, apparently not. I started my Subaru and let it warm up. I had read a comment from someone who experienced their idle going up a bit. Mine did not. It's about 700 RPM as it always has been.Bottom Line --- Very happy with Product. It is Well Made, looks good and I hope my future experience will prove it was worth installing. All Hoses etc, worked for me. Didn't need to visit an Autozone to complete my project, and had Fun during the Install.
Oritse
Comentado en los Estados Unidos el 24 de septiembre de 2020
This little modification worked a miracle. I specifically bought it to redirect the flow of oil away from the air filter. Not only does it get the job done but it got rid of my check engine light!! I have been looking at that light for 9 months and I finally bought the part to fix the light but this product did the job for me!! I'm impressed.
Jasim Alqadi
It is quality made
Productos recomendados
Mex $297.19
Mex $ 154 .00 Mex $154.00
Mex $212.93
Mex $ 114 .00 Mex $114.00
Mex $414.60
Mex $ 207 .00 Mex $207.00
Mex $1,569.96
Mex $ 659 .00 Mex $659.00