Lost In Craft
Comentado en los Estados Unidos el 29 de marzo de 2025
I used similar scorers before, when one already came with the adhesive pre-applied, and another was similar to this one when you need to apply that adhesive strip to the back of the plastic piece, and then apply it to the racket. To be honest, I didn't like it back then, and I don't like it with this set as well. But this particular set seems to be wider than the other ones I had, and it didn't work for the throat of my Head Instinct 2025. The plastic part was too big to cover the whole surface comfortably without lifting on the sides, plus, I had such a hard time applying the strip to the plastic and then trying to take the paper off the back before applying to the racket itself. When I finally managed to do that through gritted teeth and lots of cursing, turns out that because my throat is slightly curved, the plastic keeps lifting off of the adhesive strip and falling off. The strip sticks well to the racket, but it doesn't do a good job with sticking to the plastic scorer. I tried a couple of strips, then I just gave up.Basically, what I'm trying to say, make sure your racket throat is level and not too small for this particular set.Not a bad price for four sets, provided it works for your racket. But if it doesn't, then it's a waste of money.
Panda55
Comentado en los Estados Unidos el 1 de abril de 2025
Does not stick well and hard to move the bottons
steve trinh
Comentado en los Estados Unidos el 4 de abril de 2025
since I have a one handed backhand, I need to mount this scorer on the inside aspect of the throat. Unfortunately the shape of the throat is not flat so the long edges can't stay flush with the racket. It is also very difficult to remove the red plastic backing off the tape, I had to use a razor blade to tease the film off under magnification. Instructions should have said to apply the adhesive tape to the scorer 1st, and then apply the assembly to the racket. Unless you do that, there is no guarantee that the back side of the plastic scorer will align with the adhesive 100%. My racket is a Wilson HyperHammer 5.3 and is pretty thick at the throat, the scorer is a little too wide for my racket. Good price for set of 4 but I don't think this will stay on too long...