No hay artículos en el carro
No hay artículos en el carro【Especificación】 - Tornillo compatible: M8 - Grosor del borde de la hoja (mm): 2 ●Ancho del borde de la hoja (mm): 13 ●Diámetro del eje (φmm): 8 ●Longitud del eje (mm): 40 ●Longitud total (mm): 105 ●Masa (g): 82 【explicación】 ● La forma del mango hace que sea fácil de aplicar el par de torque. ● Para tornillos de montaje de cámara. Nota: ● No gires la tubería en el agujero del agarre.
小野光成
Comentado en Japón el 21 de abril de 2024
今まで500円玉を使用していましたが、締め付けが十分でなく、緩むことがありました。このドライバーに変えてきつく締められるようになりました。持ちて部分も縦長ではなく横に広いので、あまり力を加えなく使えます。
Ashley Hardman
Comentado en Canadá el 12 de diciembre de 2022
This is a camera assistants must have! So far it’s working just like the more expensive branded ones and is sturdy. You can keep it neatly in your pouch or in your on set ditty bags. I would recommend it!
Christian Tejada
Comentado en Australia el 1 de noviembre de 2022
It’s perfect: simple, and gets the job done! Defs becoming a regular tool in my kit!
ZURIEL Q.
Comentado en México el 19 de octubre de 2022
La herramienta perfecta
Customer
Comentado en los Estados Unidos el 5 de noviembre de 2021
A stubby cross handled screwdriver that has a parallel ground blade tip. The screwdriver resists camming out of a slotted head when torque is applied. Useful when a bit of extra pressure is needed to snug up connections especially on what is often worn motion picture rental equipment. Intended for 3/8-16 tie down screws it is handy to just put in your pocket while working instead of setting down a long handled screwdriver somewhere where you won't remember by the next time you need it, or saving you a trip to your cart or your tool bag because you don't want to stick a long handled screwdriver in your belt or your boot or your pocket. Because the tie down screw slots are not all exactly the same width the blade sometimes has a little bit of play in the slot but that is unavoidable if you don't want a blade that is too thick to enter the narrowest slots. Keep the tool at 90 degrees to the screw head and keep pressure down into the slot and it won't cam out. The only negative about this tool is that is seems to spontaneously grow legs and walk away. Mine has an autographed handle!
ste
Comentado en Italia el 9 de noviembre de 2017
Cacciavite per cinematografia, e produzioni video. Spettacolare. Misura perfetta per il serraggio delle viti da 1/4 e 3/8. Un po' costoso. Normalmente nei cacciaviti comuni con quella misura di punta, lo stelo è molto lungo e questo rende difficile l'utilizzo, perchè tende a scivolare fuori dal taglio della vite.Questo cacciavite assicura una ottima presa e una grande coppia di serraggio
Productos recomendados