No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Manolo Intriago
Comentado en México el 8 de diciembre de 2023
Cortan de forma excelente
Stune
Comentado en Canadá el 3 de abril de 2023
Perfect for small fine details. Does the job where end-mills and 30 degree v-bits wont work. Works great in plywood.
Gabriel mancera h.
Comentado en México el 3 de julio de 2022
Se ven de buena calidad me sirvieron mucho.y se me hicieron muy económicas.Me gustan.
Jose Isabel Galindo Martinez
Comentado en México el 7 de febrero de 2022
De mediana calidad, hay que tener mucho cuidado al setear el cnc porque son algo frágiles debido a sus dimensiones .
Customer
Comentado en México el 22 de noviembre de 2021
Obtuve un producto distinto, intente buscar si hay garantía pero solo existe la parte de devolución. Realmente me interesa tener el producto que realmente promocionan en amazon
Newyorka
Comentado en los Estados Unidos el 6 de octubre de 2020
The Walfront and BQLZR bits are identical, and are all JUNK! What good is a 0.1mm bit that is ground off center by 0.3mm?Out of two 10 packs, one each vendor, 4 had the tip pre-broken off, 2 were not ground to spec, and the rest were off center so bad the cut path was 0.45 to 0.60mm!With the Yito(?) 10/15/20/30' 0.1mm bit assortment packs, I have cut a few PCBs with 0.1mm lines on 0.15spacing no problem. I am waiting on two other vendors' product to evaluate them.If you waste time trying these, put a field microscope on the bit and spin it, after you load it in the spindle, you will see what I mean.
Gary
Comentado en los Estados Unidos el 13 de julio de 2019
The end wore off the end during the first use in soft wood! Can not believe that this is a carbide bit
William Bennett
Comentado en Canadá el 24 de diciembre de 2018
These are marketed for making PCBs, but I use them most often for cutting veneer on my CNC. These make a cut just about as smooth as a sharp knife.
Rav
Comentado en los Estados Unidos el 22 de octubre de 2017
I chose 1 day pickup and it was shipped really quick, got it next day! I have used it on a 0.4mm pitch pcb single sided without auto levelling and it worked out perfectly.(small angle engravers are way to go for small pitch). I have not tested out all bits I but eyeballing a few tells me that there are some slightly imperfect bits and they are not all for same batch or maybe even the same manufacturer (total height difference). Overall excellent for their price. Would reorder!
Productos recomendados
Mex $1,272.13
Mex $ 636 .00 Mex $636.00
Mex $539.56
Mex $ 258 .00 Mex $258.00
Mex $596.18
Mex $ 327 .00 Mex $327.00