No hay artículos en el carro
No hay artículos en el carroMás información del producto
OEMTOOLS 25553 MacPherson Strut Compresor de resorte
Obtén el mejor compresor de resorte MacPherson para el trabajo. Retira y reemplaza fácilmente tu resorte MacPherson con sus amplios ganchos de contacto y pasadores de retención. Nuestra cabeza hexagonal de 19 mm en la varilla roscada está torcida a mano con un carraca o llave. Nuestros pasadores de retención mantendrán el resorte en su lugar mientras comprimes uniformemente las varillas roscadas. Sepa que cuando utilice nuestro compresor de resorte, obtendrá una extracción rápida, fácil y segura de muelles MacPherson.
Herramienta de mantenimiento segura del puntal
La compresión del puntal puede ser un trabajo peligroso. Con nuestro compresor de resorte MacPherson, obtendrás seguridad durante la compresión y un agarre apretado de los pasadores de retención durante la extracción del resorte. Añade compuesto antiagarre a la varilla roscada antes de utilizar el compresor de resorte de puntal para un funcionamiento óptimo de la herramienta. Podrás acceder a tus puntales doblados, tubos de puntal y cartuchos de puntal de forma segura gracias a nuestra herramienta de compresión de calidad.
Herramienta esencial de mantenimiento de montaje de puntal duradera
El material no solo puede ser más barato para no hacer tus trabajos de compresión de resorte de puntal, el material inferior puede doblarse y romperse bajo la presión. Nuestras varillas duraderas tratadas térmicamente no se doblan ni se rompen durante compresiones uniformes entre las varillas roscadas. Torre fácilmente la cabeza hexagonal de 19 mm en las varillas roscadas del compresor de resorte de puntal OEM con un carraca o llave, intercambiando uniformemente entre las dos varillas roscadas mientras comprimes. Fija las varillas roscadas del compresor de bobina de resorte para que los ganchos estén separados a 180° grados y puedan torsión. Con una longitud máxima roscada de 9 pulgadas, podrás dar servicio a la mayoría de vehículos que cuentan con muelles de puntal MacPherson.
José Antonio concas
Comentado en México el 11 de agosto de 2024
Muy buen producto
Rodrigo Barrón Vázquez
Comentado en México el 12 de junio de 2024
Buen material y precio calidad
james thomas
Comentado en los Estados Unidos el 25 de noviembre de 2024
Shipped fast. They fit my springs. Easy to store away. Thick. Installation was a breeze. Value for the low.
Mark Lohr
Comentado en Australia el 20 de noviembre de 2024
I used these compressors to rebuild the front suspension on our BMW X5. I was worried they wouldn’t be up for the job given that they are so cheap. Boy was I wrong. They made it look easy.Excellent quality. Highly recommended
BCforme
Comentado en Canadá el 12 de agosto de 2023
Took some fidgeting to get them mounted. Due to the shape of the shock tower hat I couldn't attach the compressors at the very ends of the springs but it wasn't an issue to get enough compression.Overall the product worked great in my application.I like the safety pins, which was the main reason I bought this particular one. The safety pins add a little frustration as they are loose fitting and can get in the way of mounting. One of the pins didn't have good clearance so required a pretty hard push to get it set, and a hammer to tap it out when the job was done.The safety pins did work while in place making the compressors more stable.If you've never used a spring compressor before the idea is to mount each one as close as possible to opposite sides and matching coils, and as close to the ends as possible, but that doesn't work out exactly on all strut/ spring configurations. My set up was a good test for how they adapt to an awkward set up. It was awkward, but worked.If it's close enough it will be ok.Gradually add compression to each side back and fourth until the spring assembly becomes unseated top and bottom (if it's unseated on one, it will be unseated on the other, but best to double check and ensure a good safety margin.) You can check when it's about to be unseated by trying to wiggle the shock tower hat. When you're close to enough compression it will start to develop play.. but make sure you don't attempt shock removal at this point as the spring still has considerable force applied. Always wait until the springs are clearly unseated before removing shock. Half a finger width or so of being unseated is enough.I turned mine manually about 4-5 half turns each back and fourth. I would have used my impact on *low speed* using the same sequence but didn't have the necessary access to the bolt heads as I had to mount the compressors inverted to get them to fit. Using an impact here can end your day instantly with injury or death if you're trigger happy with it.I don't know how many times these can be used so I didn't rate durability, or if they can handle the stress of a large truck spring but they were fine for a compact SUV.I would buy again or recommend to a friend if needed for a similar job.
Jen
Comentado en Australia el 3 de julio de 2023
Used it for my 06 Fiat ducato front suspension to change shocks with great success. This is my first time using spring compressors and using these branded one performed better/safer than unbranded cheap ones. The very first time I used it I hooked it only on 3 coils and it didn't work, so later I reset it hooking over 4 coils as in the picture and it compressed easily. I had to back the screw right till the end to get it over the 4 coils, but once it's on it compressed nicely with lots of thread behind as in picture. The pins don't quite go over the coil diameter, but I used a hammer to persuade it on there, down side is it chips the paint on the coils. Other than that, the spring compressors came in a small cardboard box as in photo.
Paulino
Comentado en México el 12 de diciembre de 2023
Llegó manchado como de aceite con óxido en las cabeza de la pieza , ahora se que es debido a que viene lubricada y debe estar lubricada para usarse.. aguanto bien. El cambio de amortiguador y comprime bien los resortes , excelente compra
Thomas D. Stimson
Comentado en los Estados Unidos el 5 de agosto de 2022
The Jinhao, Zoohot, dragon pen is wrong in so many ways. It's too heavy to write with easily, the stainless steel nib is very stiff and the design of the pen is, let's face it, absurd. That being said, I love it. I bought the red and black versions. The dragon in both versions has gleaming, red, glass eyes. The pen is built like a battleship. It feels indestructible, and the finish on this all metal pen is flawless. I don't know how such an elaborately detailed pen can be so inexpensive. If you want a pen for taking copious notes, this probably isn't it, but if you want a pen that is really really cool, I urge you to get this one. You'll never find a better bargain.
Thriftymind
Comentado en los Estados Unidos el 25 de marzo de 2021
This pen is beyond gorgeous better than what I expected. I love my older pen but this one is thick, heavy made of metal and the color is ideal for this style pen. Easy to refill for many years of use. Writing is bold smooth yet elegant with the right ink. So many compliments on this pen. Definitely a pen you keep on you and not lose sight of. When you do use this pen it will catch people's attention so be prepared to show it off.
Baron Booth
Comentado en los Estados Unidos el 8 de agosto de 2020
This is a real nice pen and I only bought it because of the Expendables movie haha it works really well, it's nice and heavy. My only complaint is that I wish it came with ink
MandyBCandy
Comentado en los Estados Unidos el 8 de mayo de 2020
This is the best pen in the entire world. I can’t believe how amazing it is! This is a pen that makes even the most impressive person take notice. A pen fit for a king.
Kunde
Comentado en Alemania el 17 de febrero de 2020
Einwandfreie Verarbeitung, die Sicherungsstifte verhindern ein rausspringen der Feder. Würde ich jederzeit wieder kaufen. Spindel sollte man etwas fetten.
Heather
Comentado en los Estados Unidos el 7 de abril de 2019
I bought this pen as a graduation present for myself. I held it, still in the box, and marveled at its weight. Then, . . . I opened it. Behold the power! This thing is a pen and a deadly assassin weapon all in one. It is well made, sturdy, and the red, faux, ruby eyes glimmer as you wield it to write hate mail to your neighbor or fight off an intruder. This pen is totally worth the cash. I love it!
Productos recomendados