No hay artículos en el carro
No hay artículos en el carroEsta es una nueva marca OEM Upgraded White Rodgers Furnace Control Board. La junta de control es el cerebro del horno.
Zee
Comentado en los Estados Unidos el 22 de febrero de 2025
Exactly what I needed, it's still working great, if I could give it 10 stars I would. Very happy with the purchase.
Briana Crawford
Comentado en los Estados Unidos el 13 de enero de 2025
Our furnace went out. After lots of troubleshooting, my husband deduced the problem and determined this to be the part. It is identical to the original and works perfectly. It saved us a lot of money for him to fix it on his own!
Ryan
Comentado en los Estados Unidos el 7 de febrero de 2023
Replacing the board fixed my furnace issue. Take your time and swap one wire at a time. Also, note that the Line and Xfmr connectors were swapped on this board from my original one, so don't blindly just move the wires w/o reading the labels.
Kevin Alexander
Comentado en los Estados Unidos el 6 de diciembre de 2023
No problems changing over to this new board. I just made sure the old part # was actually compatible. The labels on new board are identical to the old one and just a few are in a slightly different spot, but not far enough where old wires won't reach. My old board was corroded on my Trane XB. Works fantastic again!
Derek C
Comentado en los Estados Unidos el 3 de octubre de 2022
The furnace repair guy said I needed a new furnace. No power to some motor that starts up before the ignotor fires up. Anyway I have no idea what I'm doing but I do have a label machine and an Amazon Account. I labeled all the wires and replaced the circut board with this one and now my furnace works great. The picture with the white board is the one I replaced with this updated board. No idea what is updated about it. it was plug and play. Had to use some needle nose plyers to get the old board off - there are little plastic clips that hold the board on. the new board comes with new clips , I used reused the old ones since they were mounted to the furnace. I just turned off the switch to the furnace made sure it had no power comming in and replaced this in about an hour most of it was labeling the wires. This saved me almost $4,000 for a new furnace or at least bought me a little more time before I need to buy a new one. I hope this helps someone.
Productos recomendados
Mex $499.99
Mex $ 229 .00 Mex $229.00
Mex $11,336.93
Mex $ 1,881 .00 Mex $1,881.00
Mex $3,836.03
Mex $ 1,841 .00 Mex $1,841.00