No hay artículos en el carro
No hay artículos en el carroInterruptor de palanca ON/ON Tipo nominal: CA 125V 6A Espacio del pin: 4 mm, ideal para guitarra eléctrica o construcción de bajo.
MrL
Comentado en los Estados Unidos el 12 de enero de 2025
It came with two switches, but I have only used one so far. It's small size is good for a tight guitar cavity, and its shaft was long enough to fit through the wood top when using one nut and one washer.
Mikey
Comentado en los Estados Unidos el 23 de agosto de 2024
Worked great on my vintage Fender Precision
Mike Henry
Comentado en los Estados Unidos el 2 de septiembre de 2023
You might need two, as I melted one by holding iron on to long.. Once you figure that out, soldering was easy. Tin your wires, and clean the tip! Used for a humbucker coil split. Works good.
Ryan Devlin
Comentado en los Estados Unidos el 31 de marzo de 2021
Bought the 2-pack to install in a PRS SE Standard to split the two humbuckers that I had previously installed. I was tired of using the push/pull tone knob (which I also replaced when wiring in these mini-switches). These fit great in the cavity with minor chiseling for depth and were easy to wire up so that each splits a separate humbucker. No complaints.
Mark C.
Comentado en los Estados Unidos el 3 de octubre de 2017
Having switches at this price point makes it possible to easily have a stock of switches that anticipate your needs rather than having to specifically order specific #pole/#throw switches as each project unfolds.They're reliable & handy: just be sure to check you understand how many poles/throws you need (and if On/On/On, which of two types you're getting).
Productos recomendados
Mex $159.00
Mex $ 92 .00 Mex $92.00
Mex $114.71
Mex $ 65 .00 Mex $65.00
Mex $111.98
Mex $ 66 .00 Mex $66.00
Mex $195.50
Mex $ 103 .00 Mex $103.00