No hay artículos en el carro
No hay artículos en el carroMás información del producto
Trinayshia Rogers
Comentado en los Estados Unidos el 1 de septiembre de 2024
If the ball joint is too loose and goes in and out of the knuckle/spendle to easily check to see if your knuckle is worn because mine expanded due to heat and I thought the wasn’t a fit .. once I got a new steering knuckle this ball joint fit perfect and good quality !!
Rolando Bentatha
Comentado en los Estados Unidos el 9 de diciembre de 2023
Moog is known for good snd heavy dity products. Used them for years. Price was very good and speed of normal delivery was sufficient.
Heidi
Comentado en los Estados Unidos el 14 de octubre de 2023
Very happy with Moog products. I couldn't comment on the ease of installation, since I'm having a friend do it.
larry creed
Comentado en Canadá el 17 de abril de 2023
I am very pleased with this product, at a very reasonable price.
Marco Antonio Mar Medina
Comentado en México el 5 de marzo de 2022
Muy buena calidad está recomendable así como el tiempo de entrega fue antes de tiempo gracias
Alvaro
Comentado en México el 30 de diciembre de 2021
Me gustaron por qué se ven de buena calidad, y quedaron perfectamente en mi camioneta Jeep liberty 2005, ahora ver qué tal se desempeñan con el tiempo de momento nos recomiendo
Corrine Turner
Comentado en los Estados Unidos el 7 de julio de 2018
Bought one for each side. Steering wheel wasn’t returning to center and ball joints were creaking. Both boots were broken, grease was gone.Can’t speak for longevity, just put these in today. Rented the press tool from the parts store and it barely opened wide enough to fit over the new lower ball joints with the press tools. Do yourself a solid and make sure you’re using the short “forging screw plug” in the end of the threaded part of the tool.I was worried the thicker base of these would rub on the CV or boot, but there’s plenty of clearance. See photo. Note that there is a notch in the boot and the words “mount inboard” on the boot. Both of mine were turned so that the grease zerk was on the aft side of the steering knuckle.Each ball joint comes with new nuts for upper ball joint, lower ball joint, and tie rod, plus grease zerk and cotter pin.Give yourself 2 days to devote to doing this at home, especially if your steering knuckle was as rusty as mine.**Update**Vehicle was totaled 2 days after installation, so I cannot speak to longevity, however, Me and my wife (it was her daily driver) were very pleased with the ride after installation. Steering wheel was returning to center, no more creaking. (Accident was NOT due to the ball joints, someone ran a stop sign and rolled out in front of my wife.)
Productos recomendados
2 Rótulas Para Horquilla Delanteras Inferiores Compatible con CHEVROLET MATIZ L4 1.0L de 2011 a 2015
Mex $1,537.00
Mex $ 753 .00 Mex $753.00