No hay artículos en el carro
No hay artículos en el carroKat Dawson
Comentado en los Estados Unidos el 21 de febrero de 2025
They work and fit properly. If this is your first time replacing these bushings on a Jeep TJ be sure to get a bushing press tool especially for the passenger side.
Ruiz
Comentado en México el 16 de julio de 2024
Ocupaba los bujes q ban en estos brazo del puente trasero
Yetti777
Comentado en los Estados Unidos el 3 de noviembre de 2023
Needed new ones for my 89 Jeep Cherokee 4.0 and these fit perfect. Good solid bushing.
Jose Guerrero
Comentado en México el 21 de octubre de 2023
Excelente muy buena calidad
Amando Arat Meraz Magaña
Comentado en México el 17 de enero de 2023
Quedan tal cual los que vienen de agencia
LUIS
Comentado en México el 28 de septiembre de 2023
Satisfecho
Jumping Bean
Comentado en los Estados Unidos el 7 de enero de 2022
Takes some time to install. Drilled out the old rubber bushing and used a cordless saw to cut a slit in the sleeve. Then I used a chisel to push the sleeve out.Install was much easier. The new bushing was in the freezer for a while since I was using a propane torch to heat and expand the housing on the axle. Don't overheat! I also used a wire brush on a drill to clean the housing. I just tapped in the new bushing. There was no issue with the bolts.NOTE. Do ONE side at a time.Tighten fully when vehicle is lowered to avoid pre load.
Dalton kilbreath
Comentado en Canadá el 29 de septiembre de 2021
Good stuff
scott
Comentado en Canadá el 24 de mayo de 2019
99 xj 3.5” lift, fit rubicon short arms,
Productos recomendados