No hay artículos en el carro
No hay artículos en el carro1
Shawn
Comentado en los Estados Unidos el 1 de marzo de 2025
Fits good just be ready to grind away the original rivets. I used a carbide bur. Everything fit
Charles
Comentado en Canadá el 24 de abril de 2025
This steering shaft coupler aka rag joint works like OEM on my 98 S10.
Dan
Comentado en los Estados Unidos el 3 de agosto de 2024
‘02 Chevy S10 ZR2. 22 years on the factory rag joint and this I’d say fixed about 85% of my steering play. Replaced all other steering components except the gearbox and it drives almost like new!I saw some noted concerns about bending the mating flange when driving out the rivets if you only grind one side. If you place an impact socketthat fits slightly loose over the head of the unground side, and hold the assembly on the edge of a work bench before you drive it out you won’t deform the flange.
Colton
Comentado en Canadá el 16 de julio de 2024
Good quality, easy to install and did what is was intended to do.Tightened the sloppy steering up, not like a new vehicle, but it’s a noticeable difference.
J Mac
Comentado en Canadá el 9 de noviembre de 2024
Perfect low cost replacement, you must be handy with a grinder to remove the rivets retaining the worn out coupler.
Productos recomendados