No hay artículos en el carro
No hay artículos en el carro Características:
El soporte de barbilla para casco de motocicleta Lupholue es especial para los amantes de la motocicleta para capturar paisajes emocionantes y maravillosos
Las almohadillas para orejas adhesivas de doble cara son tan fuertes para fijar la cámara de acción firmemente y estable. Adecuado para la mayoría de cascos, ya sea con barbilla larga o corta.
Instrucciones
1. Limpia el casco, rompe la cinta adhesiva de doble cara y pégala en el casco.
2. Cuelga la hebilla de seguridad en la interfaz de la cámara y el soporte.
3. Fija la hebilla de seguridad al casco.
igor
Comentado en los Estados Unidos el 7 de marzo de 2025
Probably the most secure chin mount. People who say their came off most likely didn't clean their helmet before applying.
Tina Dixon
Comentado en Canadá el 24 de abril de 2025
Quality piece shipped fast
Floris Visser
Comentado en Canadá el 9 de noviembre de 2024
Functionality and ease of installation
Phil Y.
Comentado en Canadá el 4 de julio de 2023
The chin mount comes with 4 adhesive pads, a thumbscrew & an additional knuckle joint. The additional joint can be used to mount the camera slightly further away from the helmet or to be positioned into a better angle.The integrated mount is flanked by 2 arms meant to attach to the helmet, but the central mount is not removable/replaceable. Also, the curve of the mount is a bit on the excessive side for most motorcycle helmets and it doesn’t make contact, so the main part that holds the camera is not glued to the helmet and only supported by the 2 pins. Personally, I think this may be a weak point if you were to accidently hit the camera. I would have preferred if the mount plate also had some adhesive on the back and would stick to the helmet.It did not include instructions, but installation was easy and the camera fit perfectly.Overall, the Lupholue motorcycle helmet chin mount work ok. Attaching the mount and camera was good, but the lack of contact of the mounting plate to the helmet due to the sharp curve was my major concern as its dependent one a couple pins to keep your camera attached. This may be something to keep an eye out for if you decide to get it or consider looking at a different product with a more secure mounting method.
David Diaz
Comentado en los Estados Unidos el 17 de noviembre de 2023
Very easy to install on my Scorpion EXO covert motorcycle helmet. There is a chin mount made for this helmet that’s 35$ but I was determined to find another chin mount that could work with this helmet, this chin mount was the one. The adhesion is very sticky but I heated mine up before sticking to the helmet and it made it much more sticky which can make a better hold hopefully in the long run. I also placed a heavy duty piece of Velcro to the mount and helmet but the mount is slightly curved which did not make a full contact to the Velcro but just a small amount. However heating the adhesion strips before sticking to the helmet will for sure be more than enough to stick to the helmet and the Velcro strips not fully making contact is just a small back up. Overall the performance of this chin mount is what I was looking for in a GoPro chin mount that can work for the Scorpion EXO covert helmet that I had recently purchased. Highly recommend this chin mount for most motorcycle helmets
Productos recomendados