No hay artículos en el carro
No hay artículos en el carroEncendedor de estufa piezoeléctrico con perilla Atwood
Harry Willems
Comentado en los Estados Unidos el 25 de marzo de 2025
Installed in less than 10 minutes. Use pliers to remove wires at the generator (take photo of wire order for reintegration). If burner(s) still won’t light make sure wires to spark generator are securely seated. In darkened area turn spark generator knob while following each wire to burner. If spark emits along the wire before the burner, tape the wire with electrical tape or replace the wire
richard fuerstenberg
Comentado en los Estados Unidos el 2 de abril de 2025
Fit our Atwood stove perfectly . Was a 5 minute swap of old defective unit and install new one . Works great . This was in a 2014 Heartland Sundance 5th wheel . I would order again if needed .
wayne anderson
Comentado en Canadá el 18 de agosto de 2024
This ignitor was exactly as the vendor described.Fit perfectly and worked first time
Customer
Comentado en Canadá el 23 de julio de 2024
Fit perfect on my trailer's stove, no more matches or lighters!!
Danny G
Comentado en Canadá el 31 de agosto de 2023
I was told this igniter wouldn’t work on the camp chef Denali 3x, they were 50% right The igniter is the same one that was in my camp chef. The only thing I needed to do was to grind down the outside of my knob about 1/8 to 1/4 inch down so it wouldn’t rub on the outside. Picture for referenceAfter removing the material on the knob it snapped in nicely works beautifully.It was an expensive way to get my camp chef igniter going again.
Productos recomendados
