No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Michael Jennings
Comentado en los Estados Unidos el 31 de enero de 2025
No se pudo cargar el contenido.
Mike B.
Comentado en los Estados Unidos el 17 de enero de 2025
I usually purchase from BBL, but decided to give these a try. I have no complaints. These are just as good as the more expensive ones I have purchased in the past.
Tornado Automation
Comentado en los Estados Unidos el 19 de abril de 2025
This is nice, looks amazing on the print, just have to add a little more heat to the bed for adhesion.
Mike P
Comentado en los Estados Unidos el 25 de abril de 2025
This plate worked perfectly at standard PETG HF settings the first couple of times that I used it, then it failed to stick on all subsequent prints. So, after lots of forum searches, experimentation, and changing one variable at a time, here's what's currently working well for my Juupine holographic plate in my Bambu P1S with .4mm nozzle:* Scrub twice with IPA using clean microfiber cloth. Dry.* Choose the smooth PEI plate in Bambu Studio.* Close BOTH glass top and door* Preheat the chamber for 15 minutes by setting bed temp to 90C* Set initial layer to: Nozzle 250C, bed 90C, speed 25mm/s.* When print finishes, keep door and top closed and let the chamber completly cool down before removing the print.The above settings worked well for me on a 200x230 mm flat shape.Other settings I use on all my PETG HF prints on all build plates:No cooling on first 7 layers, aux fan off, 10mm brim for all large, flat prints.
Jake Carter
Comentado en los Estados Unidos el 19 de diciembre de 2024
There must be quality control issues with these plates given the mixed reviews. I have tried hard to get this plate to work for a single print. I have tried a dozen brands of filament, PLA and PETG from each. I have cleaned with Dawn dish soap, used 99.9% IPA, tried all of the settings mentioned in the reviews. Tried every build plate option, fan off/on, etc. Even tried glue, which I have never had to use on any other build plate with my 8 Bambu printers (P1P, P1S, and X1C). I have not seen more than 50mm of a single line of filament stick. As soon as there is a change in the path it drags the printed filament off of the bed. I might as well try to clean the bed with motor oil, it would stick the same. It is now in the trash where it belongs.
Productos recomendados
Mex $534.47
Mex $ 267 .00 Mex $267.00
Mex $787.54
Mex $ 385 .00 Mex $385.00