No hay artículos en el carro
No hay artículos en el carro Embalaje
1 cabeza aburrida de 2 pulgadas.
1 vástago R8.
Barra de perforación de carburo de 9 x 1/2 pulgadas.
3 llaves allen.
Tamaño del producto:
Tamaño de la cabeza: 2 pulgadas.
Agujero de la barra de mandrinar: 1/2"
Diámetro del agujero de la cruz: 1/2"
Desplazamiento máximo: 5/8"
Graduaciones: 0.001/0-50
Distancia central bt 2 agujero inferior: 1,5 cm.
Servicio:
Proporcionaremos un servicio de 24 meses, si tienes alguna pregunta, ponte en contacto con nosotros,
Te responderemos lo antes posible.
Michael W. Bogausch
Comentado en los Estados Unidos el 9 de noviembre de 2024
No se pudo cargar el contenido.
Lwood
Comentado en los Estados Unidos el 20 de diciembre de 2022
The case didn’t make it very well the inside where the boring bar sets both ends where cracked out and a few of the boring bars themselves had chipped from rattling around in the case, contacted CS and reply was owell. Also plan on spending time to take apart and clean the swarf out along with the rust, the end 16/20 threads need to be re-threaded.
Eric D Nelson
Comentado en los Estados Unidos el 21 de octubre de 2022
Pros:* CheapCons:* The case does not hold the items well. The first set I received had chipped carbide boring bars. Inside all the bars were banning around during shipment. The second set I received was the same, except I didn't have any chipped carbide this time.* The draw bar threads on the R8 shank were so poorly cut that I could not tighten the boring head in the mill. I chased the threads with a 7/16-20 tap and now it works.* The carbide insert on the boring bars appear to be aligned "by eye". As I bored a hole the trailing edge of the carbide cut a larger hole than the leading edge. Each bar had the carbide installed at different angles. I had to regrined.* If you want to cut an O.D. with this by running in reverse, your out of luck. The boring head is screwed onto the R8 shank. If you run in reverse, the boring head will fall off the R8 shank.You get what you pay for. Plan on doing some work to get this to function. It will bore holes after some work, But the holes are berry rough looking.
Productos recomendados
Mex $385.00
Mex $ 204 .00 Mex $204.00
Mex $308.00
Mex $ 154 .00 Mex $154.00
Mex $352.25
Mex $ 169 .00 Mex $169.00