No hay artículos en el carro
No hay artículos en el carro Esta caja de fusibles de hoja de 12 circuitos ampliamente utilizada en automóviles, autobuses, cisternas, barcos, marinas, camiones, SUV, yates, RV, barcos, etc.
➤Especificaciones:
Entrada: 12-32 V CC.
Abrazadera de línea principal: tornillo roscado M5.
[Cable tronco]: # 4-8
Terminal de línea única: pernos roscados M4.
[Cable único]: # 12-16
Corriente de entrada/salida: 100A/30A máx. por circuito
Material: base PBT + ABS + cobre.
Indicador de seguridad LED
➤ La luz LED roja se iluminará inmediatamente cuando se sopla el fusible correspondiente.
➤ Seguro y fácil de comprobar y reemplazar el soplado.
➤ Funda protectora con cierre de clic.
➤ Con protección contra salpicaduras y prevención de polvo, la cubierta aislante con sistema de pestillo añade seguridad adicional a la caja y los fusibles y te ayuda a abrir fácilmente presionándolo.
Mantén el cableado limpio
➤ El calcomanía multifuncional hace que el revisión y la reparación sean convenientes, puedes identificar qué aparato se va mal fácilmente.
➤ Perfecto para solucionar problemas al aire última intervensión.
El paquete incluye:
1 caja de fusibles de 12 vías.
Hoja de fusible naranja 5 x 5 A.
Hoja de fusible roja de 5 x 10 A.
Hoja de fusible azul de 5 x 15 A.
5 cuchillas de fusible amarillas de 20 A.
Hoja de fusible blanca de 5 x 25 A.
1 clip de seguridad.
2 pegatinas.
4 tornillos.
Servicio posventa:
Ofrecemos 1 año de garantía para todos nuestros productos desde el día de la compra.
Fred H.
Comentado en los Estados Unidos el 9 de junio de 2022
A good buy, worked perfect for the boat
Alvaro Gonzalez
Comentado en México el 25 de septiembre de 2022
Buen producto
Man
Comentado en los Estados Unidos el 24 de junio de 2021
Update: just a few comments after installing and using the unit. First, you might think that you have leaking voltage if you put a multimeter between the positive and negative on an unfused terminal while connected to a power source. At the time of my original review, I tested for continuity with my multimeter, but didn't have power connected. You should not be concerned if you see voltage across the positive and negative terminals with a blown fuse. Why? To satisfy myself that the device was working, I removed the back cover but did not remove the circuit board. There must be a diode on the circuit board that drives the LEDs that light when a fuse is blown. Diodes allow the flow of current in only one direction and current is needed to light the LEDs. I put my multimeter in diode testing mode and verified that current can only flow in one direction when there is a blown fuse or no fuse. That direction is to the LED. No current flows to a device connected to the terminals as expected.One negative that resulted in me removing one star from my review is that the main positive terminal is a bit loosey-goosey due to not being attached very well. The whole positive terminal board inside the unit is actually flexing. This is easily resolved by putting a washer minimally on the outside to prevent the the bottom nut from moving through the plastic hole to the back of the unit. I added a washer on both sides both to secure and keep the internal bus bar from bending. I would have liked to see them either make this modification at the factory or simply make the plastic hole smaller. After making the modification my main positive terminal is extremely secure. I included a picture of the mod.Original: I haven't installed in my solar system yet, but tested with a multimeter and everything checks out. I like the knob for closing and opening the front panel because it doesn't rely purely on a clip system that is likely to break with repeated use. There are clips, but they seem sturdy enough as long as you don't force anything.
María Samaniego
Comentado en los Estados Unidos el 5 de enero de 2021
Like how the cover locks so it doesn’t come off
Jesse
Comentado en los Estados Unidos el 8 de septiembre de 2021
Nice fuse panel the top panel is a little bulky in my opinion bedsides that great fuse panel tons of extra fuses included and stickers to mark each fuse also has LED to indicate which fuse is blown
Albert Fortner
Comentado en los Estados Unidos el 21 de septiembre de 2021
Perfecr
Productos recomendados
Mex $392.00
Mex $ 176 .00 Mex $176.00
Mex $2,531.86
Mex $ 1,164 .00 Mex $1,164.00
Mex $227.00
Mex $ 124 .00 Mex $124.00
Mex $198.00
Mex $ 114 .00 Mex $114.00