Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

Inkbird Sonda de Acuarios de Repuesto para ITC-308S Termostato Digital

Envío gratis en pedidos superiores a $600MXN

$341MXN

$ 177 MXN $177MXN

En stock

Acerca de este artículo

  • ◆ La sonda puedes medición de temperatura rango: -50 ~ 99 ° C / -58 ~ 210 ° F.
  • ◆ Sonda Dimensiones: 6 mm x 50 mm (0.24in x 1.97in).
  • ◆ La larga de la sonda es 5cm/1.97'', muy adecuado usar para acuarios.
  • ◆ La sonda se puede colocar en agua de mar para detectar la temperatura. Es una sonda de acuario profesional.
  • ◆ Adecuado para todos Inkbird Termostato ( ITC-308S, ITC-308, ITC-306T, ITC-310T, ITC-1000, ITC-2000)



Descripción del producto

Especificaciones:

Rango de temperatura de medición: -50 °C ~ 99 °C / -50 °C ~ 210 °F

Material de la sonda: material plástico.

Longitud del cable (sin sonda): 2 m

El paquete incluye:

1 sonda de acuario desmontable


Cliente de
Comentado en México el 24 de febrero de 2025
Excelente repuesto lo conecte y funcionó perfectamente
jae w jung
Comentado en los Estados Unidos el 1 de enero de 2025
It works. I use it for my temperature controller for a freshwater aquarium set up. I would recommend the product. Only issue would be that they need to replaced every few years. They randomly just stop working properly after a few years.
Shorti69
Comentado en los Estados Unidos el 28 de diciembre de 2024
Does the job
Tyler J
Comentado en los Estados Unidos el 20 de noviembre de 2024
Thanks inkbird for offering an upgrade/ replacement so I didn't have to junk my whole temp controller unit. I like the plug and waterproof sensor in this version. It's sure to help me avoid damaging it in the future.
Aaron
Comentado en los Estados Unidos el 22 de noviembre de 2022
This probe is great, especially convenient in that you can change probes without soldering in the future, but unfortunately you have to solder the new socket for the initial setup with certain inkbird controllers. I have the Inkbird WiFi ITC-308.Setup:I re-used the motherboard connector from the original probe, stripped the thin wires with a lighter, and then connected/twisted the new probe wires together. After that I used heat shrink around the new connection. Pretty easy, but the device shouldn't require such a technical procedure to simply install marine aquarium appropriate temp probes, and makes me worry about a voided warranty.
Mac
Comentado en los Estados Unidos el 17 de julio de 2021
It was unclear from the product description if I could use this with an ITC-308. When I purchased my unit I knew that the probe wasn't rated to be continuously submerged, but I took a chance. After a couple of years, the probe failed and it started reading well above my high alarm threshold. I ordered this replacement sensor and installed it. The sensor works great, is now designed to be used submerged, and it has a plug so if I need to replace it again I can easily swap it out.
Productos recomendados

$3,279MXN

$ 1,541 MXN $1,541MXN

4.6
Elegir