No hay artículos en el carro
No hay artículos en el carroStanG
Comentado en los Estados Unidos el 31 de marzo de 2025
I've been using the HQMaster Up & Down Cut Compression Bits (1/8" Shank) on my 24x48 CNC to cut hardwoods like walnut and maple, and they've performed exceptionally well. The longevity is impressive, especially considering the price.Like any bit, they can break on knots, but I’ve found this usually happens when my speed and RPM settings aren't properly adjusted, not due to the bit itself. When dialed in correctly, these bits cut cleanly and hold up just as well—if not better—than some better-known brands I've tried.For anyone working with hardwood, these are a solid 5-star choice. Highly recommended!
KK
Comentado en los Estados Unidos el 9 de agosto de 2024
All good
David j
Comentado en Australia el 24 de agosto de 2024
Just ordered another 101500mm min 1.5 deep in hardwood, and Australian Spotted gum too!
Ryan
Comentado en los Estados Unidos el 18 de noviembre de 2024
What's not to like? Economically priced and they work great. This 5-pack costs less than one single bit from other brands and they cust just as cleanly.
Tim Handy
Comentado en los Estados Unidos el 10 de diciembre de 2023
I really like these and will buy again. These compression bits have last a good while also. I really like the short compression tip on these. Others you have to go .200 on the 1st pass to get deep enough for the down cut of the tool.
Productos recomendados