No hay artículos en el carro
No hay artículos en el carroSirIvan
Comentado en los Estados Unidos el 21 de agosto de 2023
No se pudo cargar el contenido.
Ed Prec
Comentado en México el 9 de noviembre de 2023
Muy util
Caleb & Diana
Comentado en los Estados Unidos el 20 de enero de 2023
I was really struggling even using the Amana o flute. I broke four bits the day before these arrived. After I got these, there was no melting, and I had beautiful edges for the next 200 cut outs I did. I’m still using the first bit of the set.
Bob
Comentado en los Estados Unidos el 20 de diciembre de 2022
I like the price of these bits. Since I only cut with a small portion of the end of any bit, these smaller bits are ideal for most of my cnc jobs.
Bruce E. Layne
Comentado en los Estados Unidos el 4 de mayo de 2018
I purchased single flute router bits and received router bits with two flutes. Not at all the same. The quality looks decent for a 2 flute router bit but this was not what was advertised.14MAY18 EDIT - The seller saw my review and insisted on sending me the correct router bits. They are good quality and the single O flute cuts well in plastic, making small but fully formed chips that eject well and do not create a bird's net of plastic filament on the router bit for linear cuts. These aren't drill bits. They can be used for drilling but they'll produce long curled chips when drilling that can attach to the bit. To avoid that problem, use a short peck drilling cycle with each peck of .05" or so. It's a lot slower but a long CNC router job can run unattended for hours when the bit stays clean. These bits are good for plastics up to 3/8" thick. They can cut 1/2 plastic but there isn't much exposed flute to eject the chip. For half inch plastic I use a similar bit from a different seller that has a longer cutting length, but the shorter flute is stiffer so it makes a more precise and clean cut because it doesn't deflect as much at higher feed rates.
Tim Monfort
Comentado en los Estados Unidos el 13 de noviembre de 2018
I was asked to do a product review of these bits. First of all they are a 1 flute end mill spiral bit. "They are not ball nose." Being said that they cut arylic plastic very fine. I was using ball nose and tried different end mill bits but just wasn't getting the smoothness i was desiring . I used these 1 flute spiral bits at a pretty high feed and and with a small amount o plunge. If you need the exact shoot me a email request. The quality of these are exceptionally well. I done at least a half dozen jobs on a ingle bit and haven't notice any dullness yet. I am highly recommending these if your working with soft plastics or doing Arylic design plate covers with led lights.Thanks for your service and honesty of these bits. Best regards: Tim monfort
Productos recomendados