No hay artículos en el carro
No hay artículos en el carroW. Wexell
Comentado en los Estados Unidos el 20 de febrero de 2025
I accidentally ganked the wires out of a harness just like this while dropping the transmission on my 987.2. The harness was for the reverse sensor so the back-up lights could come on when I put the car in reverse.This connector was an exact replacement, though the wire colors were different. I soldered this into the existing incoming wires, plugged it in, zip tied up the excess and haven't looked back sense.Definitely cheaper than what the dealership wanted for the same connector.
Ethan P
Comentado en los Estados Unidos el 1 de febrero de 2025
Replaced my reverse lamp switch pigtail on my mk4 TDI 5-speed due to a broken wire. Connector fit snug and perfectly, nice 18 AWG wires. Would buy again. Very good quality.
alagomez
Comentado en los Estados Unidos el 24 de enero de 2025
This came in clutch when making a pigtail for a cam solenoid. The connector fits well, you hear a good click when it engages. The gauge of wire is a little thin, but will definitely do for low-voltage sensors. Definitely gonna buy more to have on hand for any future projects.
Erick
Comentado en los Estados Unidos el 12 de abril de 2025
This part worked well for my Audi my housing clip had gone bad I went to the dealer and there’s wasn’t good I ordered another one on here and it came with the wires connected already , I highly recommend this now my car is cooling !
poolenglish
Comentado en los Estados Unidos el 9 de diciembre de 2023
Does not fit 2006 VW Jetta. It connects but snap lock clip is on the wrong side. I had to use zip ties to lock it down.
Productos recomendados