No hay artículos en el carro
No hay artículos en el carroFeatures solid carbide head with four carbide cutting edges in "X" configuration, for optimum drilling performance. Special two-component tungsten carbide incorporating gradient technology for superior impact absorption such as when drilling into rebar and high resistance to overheating such as when drilling through pre-drilled steel plates. New helix design for rapid drilling progress - each carbide cutting edge runs out into its own flute, ensuring excellent removal of dust and fragments.
Bill P.
Comentado en los Estados Unidos el 20 de mayo de 2024
I like the end of this bit better than the normal two sided carbide tip. Drills easier.
Brad
Comentado en los Estados Unidos el 5 de julio de 2021
You need an SDS drill or your hammer drill will be ruined. There should be a warning posted because this is not common knowledge. Note: I was given a full refund.
dave i.
Comentado en los Estados Unidos el 10 de noviembre de 2019
these are the best you can get, I use them in a bosh with a chuck, perfect
Philip W. Gorrell
Comentado en los Estados Unidos el 7 de octubre de 2015
all as described
Productos recomendados
Mex $276.07
Mex $ 154 .00 Mex $154.00