No hay artículos en el carro
No hay artículos en el carroAquí hay 3 piezas. Juego de cortadores de moscas que es difícil de superar. Cada uno se suministra con acabado de óxido negro, un tornillo de fijación plano y una herramienta de acero de alta velocidad en blanco.
commandhugh
Comentado en Canadá el 23 de febrero de 2024
well made great price fast shipping thank you
Dan S 1
Comentado en los Estados Unidos el 25 de marzo de 2020
I haven't used these yet, but upon opening the package, I see that the cutter on the largest one (all cutters are the same size) is so short that only two of the three set screws actually hold it. It should have had a longer cutter to accommodate the larger slot. Also the hex wrench that is included does not fit snugly into the set screws and is so weak that it rounded off almost immediately. Other than that, they seem to be of good quality. I will add more after using them.
s levasseur
Comentado en Canadá el 4 de septiembre de 2015
very good tool for the price well made clean cutting
RWB
Comentado en los Estados Unidos el 2 de noviembre de 2013
Excellent low-end product at a cost that is less than the US supplier (prime member). The machining blanks are not pre-ground (normal) but are of high quality and the combination can provide a very smooth surface. I have used the smallest with both a mill and drill press and am very impressed with the results. As with every product the results will depend on the operator, so if you are not familiar with fly-cutters, read up on them before taking your first cut. Caution, with this style of cutter the cuts should be on solid surface and not on the material, then off and on, etc.
JRucks
Comentado en los Estados Unidos el 6 de septiembre de 2012
Works great, low price, can't complain. I would have hoped for a guide on grinding your own cutter bits, though. Because I don't know much about it at all. If nothing else, don't include the HSS stock at all and require it to be purchased separately. That's just my personal opinion, though.The cutters can also be ground to bore large holes (cylinder boring, final cuts for press-fit bearings, etc), so that is a major plus. As fly cutters, they work well if they are sharp and ground correctly.
Productos recomendados