No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Resistencia a la corrosión
Resistencia y durabilidad
Aplicación versátil
Phillip Howard
Comentado en los Estados Unidos el 18 de febrero de 2025
The T handle would not clear the engine block so l had to send it back. Ended up buying one that had a sliding T handle.
Mak
Comentado en los Estados Unidos el 20 de diciembre de 2024
Works great and nice stainless construction.
Yacht Design Software Developer
Comentado en los Estados Unidos el 7 de octubre de 2024
The general quality of the remover was good but the tightening handles had very poor thread quality. I found it very difficult to turn the handles every 1-2 turns. This made it very difficult to tighten the puller arms onto the impeller so that it could be removed. I was forced to use a large set of adjustable pliers to turn the handles so that it would grasp the impeller with sufficient force to actually remove it from the pump. I believe the threads were not machined correctly. The rest of the item is very strongly made and did the job just fine once I forced the handles tight with my large pliers.Please note that the dimensions given for impeller size refer to the center section of the impeller and not the overall diameter of the impeller. My attached photo shows you the dimension you must measure in order to be sure that this remover will work with your pump. Note that the puller will NOT work with an impeller that is larger than the specified 2-9/16" dimension because the arms cannot close enough to grip the impeller and remove it.
Productos recomendados
Mex $119.00
Mex $ 60 .00 Mex $60.00
Mex $2,751.50
Mex $ 1,210 .00 Mex $1,210.00
Mex $498.00
Mex $ 263 .00 Mex $263.00