No hay artículos en el carro
No hay artículos en el carroGM GM 19209664 - Emblema para puerta elevada, color dorado
David
Comentado en Canadá el 13 de mayo de 2024
Just like the original
william allan
Comentado en el Reino Unido el 30 de septiembre de 2024
Better than I expected good quality and easy to fix to the car
ELothamer
Comentado en los Estados Unidos el 29 de abril de 2024
I ordered 2 from other sellers and they were not the right size or fit. This has the bend in it and is the same size.
Jose angel espinosa
Comentado en México el 30 de diciembre de 2023
No es para la camioneta q ahí está especificado dice q ala Chevrolet Uplander no le quedó es falso eso
Customer
Comentado en Canadá el 2 de agosto de 2017
works but is not the correct size. Add said genuine emblem but it is much smaller.
Jerry Smitt
Comentado en los Estados Unidos el 15 de mayo de 2015
I have a 2008 Chevy HHR LT and it was difficult to identify what part to order because it is a factory defect that the outer bowtie comes discolored and will eventually fall off. Just look at HHR's in parking lots. A friend tried to repaind the plasitc outer bowtie and reglue it. I looked great for 3 days.This is official GM part. I wondered if I would have to unsrew the hex bolts underneath the tailgate/ switch mechanism. I did not want to. I was not sure how the bowtie was attached since I had already repainted/ glued it 6 months prior.Here is the deal: the bowtie/ the same that comes from Amazon, Is attached to the vehicle by adhesive. So, in order to attach new Bowtite emblem, you must remove old with out scratching paint. Notice 2 studs in picture and peel back adhesive strip. That's what there is once you need once old emblem is removed. After much discussion, I said screw it, I'm going to do take it off gently. It was a hot day, I recommend that or a hair dryer in a pinch. I took a long razor blade utility knife and carefully worked my way in between the emblem and the vehicle in a back and forth motion. Basically, you are sawing the adhesive with that long razor sharp utility knife. It took some time.Remember the 2 studs to work around finally I removed it. There was much black adhesive remaining which I remove with Goof-Off and several tack cloths. It also provided a clean surface to apply the new emblem. I lined the 2 studs to 2 holes in the body of the car, removed the adhesive protective strip and careful stuck it on, held with pressure for 2-4 minutes. It looks like new. Not bad for $30
Productos recomendados
Mex $387.51
Mex $ 197 .00 Mex $197.00
Mex $383.66
Mex $ 199 .00 Mex $199.00
Mex $294.18
Mex $ 144 .00 Mex $144.00
Mex $289.22
Mex $ 156 .00 Mex $156.00