No hay artículos en el carro
No hay artículos en el carroEsta cuchilla superior proporciona acabados de vidrio suave al cortar maderas duras y blandas, por lo que no es necesario lijar. Lo que hace que esta hoja sea tan especial es el afilado lateral único de cada diente. Los dientes realmente pulen el material a medida que se corta. Las nuevas ranuras antivibración cortadas con láser prácticamente eliminan la vibración que resuena en las cuchillas estándar, produciendo acabados de vidrio suave. ¡Con un acabado tan perfecto no necesitarás estabilizadores!
Consejero
Comentado en los Estados Unidos el 24 de febrero de 2025
This Freud blade is phenomenal. I had read many reviews where customers were not happy with the finish left behind after completion of the cut. The Freud rating tree depicts the blade as moderate satisfaction for veneers on their comparison charts as well due to tooth rake. I have been framing a stretched canvas painting as a gift for our pastor. The frame material was 2 1/4" sloped walnut with inlaid marquetry on the entire length and the most expensive frame trim that I have ever bought. As a preliminary test I made an initial miter eliminating my normal process of using masking tape to protect the veneer. The blade produced a super smooth cut with no chipping of the marquetry and the miters joined up flawless. I finished out the entire frame without utilizing masking tape with a chip free perfect match up on the miters. Some of my cuts were less than a blade width thick as I matched up the lengths. I had zero issues with the blade and actually did not have to spend additional funds for a miter trimmer to shave the trim due to the smooth cuts. Even on a miter saw the primary issue with any tool is technique. Allowing the blade to remain down until it is done spinning is key for a smooth cut. The blade was accurate with zero burning and perfect accuracy. I have always loved Freud blades and bits. This further cements my loyalty to the Freud product line as my first choice when available. As a note: I returned the original blade because I accidentally ordered a 10" rather than a 12" blade. I ordered the correct 12" size immediately. You will not find a smoother saw blade,
Kiwigrunt
Comentado en Australia el 6 de enero de 2025
Just put it on my mitre saw and did some test cuts. It cuts pretty good. The thick kerf makes it very stiff. All my thin kerf blades flex with big compound mitre cuts and leave a less than impressive cut. This blade still leaves some very minor marks that may be due to the hungry 10 degree rake. Still, I knew it had that rake so I can't complain about that. What I can complain about is the fact that it is not 10" but 250mm. Not a big difference, but a difference none the less.
Phil B.
Comentado en los Estados Unidos el 18 de abril de 2025
What a great 12" blade resulting in extremely smooth cuts. Rids sanding of edges you wish to fasten together. Super high quality.
luc l.
Comentado en Canadá el 5 de mayo de 2024
BEST YOU CAN GET !!
Customer
Comentado en Canadá el 18 de marzo de 2021
Excellent. Just finished large restaurant millwork job. cut 3000+ ft of oak trim+ mdf veneer. 2 months of flawless cuts.
Productos recomendados
Mex $669.21
Mex $ 334 .00 Mex $334.00
Mex $190.00
Mex $ 100 .00 Mex $100.00
Mex $586.00
Mex $ 269 .00 Mex $269.00