Carro de la compra

No hay artículos en el carro

No hay artículos en el carro

Freud - Broca para abalorio de radio de 3/8 pulgadas (corte cuadra)

Envío gratis en pedidos superiores a Mex $600.00

Mex $717.44

Mex $ 373 .00 Mex $373.00

En stock

1.Nombredelestilo:Broca De Enrutador De Abalorio De Radio De 1-1/4 Pulgadas Con Vástago De 1/2 Pulgadas


Acerca de este artículo

  • Broca de abalorio de radio de 3/8 pulgadas (corte cuadrádra)
  • Broca de abalorio de radio de 3/8 pulgadas (corte cuadrádra)
  • Broca de abalorio de radio de 3/8 pulgadas (corte cuadrádra)
  • Broca de abalorio de radio de 3/8 pulgadas (corte cuadrádra)
  • Broca de abalorio de radio de 3/8 pulgadas (corte cuadrádra)


Freud-Diablo 36-124 - Broca de abalorio de radio de 3/8 pulgadas (corte cuadra),


burkbuilds
Comentado en los Estados Unidos el 12 de marzo de 2025
This bit does a great job and has very little tear out even at the corners of end grain. It has held up well and gives a smooth cut that requires only a couple of grits of sanding to be ready for finish.
Gary jenison
Comentado en los Estados Unidos el 6 de febrero de 2024
Second Freud product to arrive damaged in factory sealed packaging.Chipped section on secondary blade did not affect cutting contour so I when ahead and used it anyway. Spun ok, bearing ok (not great). Cut through 3/4” cherry without chatter and left nice surface. Note I treat endgrain and miter joints with great respect and shave cuts VERY gradually so I’m not sure how this bit would fair were you to just blaze through cuts in a single pass. Apparent factory quality control means this is probably my last Freud purchase.
JMGT
Comentado en los Estados Unidos el 3 de septiembre de 2024
Great bit for easing sharpe edges of boards
Marc Pelletier
Comentado en los Estados Unidos el 19 de noviembre de 2019
The 7/8” bit is quite large (2-1/4” overall) and requires a steady hand to use. I mounted it in my router table to create the profile, and it was an effort for me (I used Gripper push blocks to push the workpiece through.) I crated column capitals using 1-1/2” western red cedar for the molding and cap.Overall, the bit worked perfectly!
Dave H.
Comentado en los Estados Unidos el 4 de enero de 2012
I bought this bit to route the bull nose to complete my raised fireplace area in the corner of our living room. The material I used was white Oak that was recycled from a building built around the turn of century. It's beautiful wood with much tighter grain than you see these days and it's hard. Very hard. Like all Freud router bits I've owned though, this made short work of it and left very little sanding for me. Truth is, if I wasn't so picky, I could have left it alone, but I sanded it to rough it up a little because it was too smooth and shiny. Sure, there are cheaper bits out there that will cut the same profile, but, they won't do it as well or for as long as a Freud.
Productos recomendados

Mex $4,042.64

Mex $ 1,617 .00 Mex $1,617.00

4.4
Elegir

Mex $3,294.34

Mex $ 1,317 .00 Mex $1,317.00

4.4
Elegir