No hay artículos en el carro
No hay artículos en el carroRin
Comentado en los Estados Unidos el 9 de marzo de 2025
I love this little rack. We were able to build out and open concept closet with these. That said make sure you don’t use anchors and actually mount it on a stud. We used anchors that far exceeded the weight capacity and these still ripped a hole in our wall
JC9
Comentado en los Estados Unidos el 1 de febrero de 2025
Great product
MB
Comentado en los Estados Unidos el 7 de enero de 2025
easy work for lathe machining
AB
Comentado en los Estados Unidos el 17 de julio de 2024
Took a while to get it right, but once I did the results were exactly what I hoped for. 10/10
lucia
Comentado en Canadá el 25 de marzo de 2024
Belles bâtonnets en cuivre
Customer
Comentado en Canadá el 25 de diciembre de 2024
Loved the quality,and fast shipping
Placeholder
Comentado en los Estados Unidos el 19 de noviembre de 2024
It wasn’t too bad to put up, the only annoying part is we couldn’t get some of the pieces to completely tighten so it felt a little wobbly. If you tried to tighten one part then something wouldn’t be straight or at the right angle to hold the shelf. It’s not super noticeable once it’s up and the shelf is on, but it’s still a little wobbly. It functions though
Customer
Comentado en los Estados Unidos el 3 de septiembre de 2024
This is exactly what you get, a piece of copper rod
Madeline
Comentado en los Estados Unidos el 8 de septiembre de 2023
These are very cool. They seem sturdy and are a great color. Two things to note:1) the paint chips off pretty easy on the flange and you can see that it is black underneath2) the hardware sent with are not strong enough to support anything hanging on the bar. This was easily solved by putting some planks on my wall and attaching them to my studs and then attaching the bars to the planks but they certainly couldn’t hold the claimed weight without additional support.
Customer
Comentado en los Estados Unidos el 3 de octubre de 2022
Really nice looking kit. Much lighter than I was anticipating, definitely not made from steel.I needed to use this mounted to the roof of a closet into a 1" plywood board, which the included pipes did not allow for because they were meant for wall mounts to allow sufficient space but it hung far too low for a ceiling mount application in a closet. To fix this I went to Home improvement store and bought the shortest 3/4" nipples they had and rather than spend $14 on a can of Gold flake Rustoleum spray paint, I found a silver and gold ink pen package nearby for 1/3 the cost, and I used the ink pen to get at least a similar gold flake color on the nipples instead of them being bare steel.I'm sure it's not a common use case, but would be nice to have an option to flush the flanges with the cross beam for those doing ceiling mounted installs.
Productos recomendados