perfect

Le montage est laborieux, ça commence avec des vis foirées.Je m'attendais à quelque chose de plus qualitatif vu le prix, les petites roulettes ne tournent pas bien et roulent mal, elles sont fixées par une pièce en plastique dont la durée de vie sera certainement assez faible. Le tout tenu par des vis foirées... Bon... Je me demande si je ne vais pas remplacer les roues par des patins, au moins ça glissera mieux.A la reception, le support vertical avait aussi une grosse rayure. L'ensemble n'est pas très joli finalement...Ca fera l'affaire en attendant de trouver mieux mais même acheté en promo je le trouve très cher pour ce que c'est.

El pedido vino incompleto y no menda opción para devolución, no trajo llantas

se adapta a diferentes alturas, no me agrada que no funcionen del todo bien las llantas

update: it took a while to figure out where to put my cup holders, my tissue box holder and where to put my TV remote, HDMI switch remote, Air purifier remote, iPhone. After all it is the command centre of my MacBooks (4 of them) connected to my 65" 4k HDR TV. Everything fitted despite the fact that the tabletop is thin sheet metal with holes and a quarter inch rim. I did use a Jenga block for the clamp of my large flask holder and that seem to work. I also found out where the C screw should go and that prevents the tabletop from the slight wobbling up and down; it does not prevent the 360 degree rotation around the feet. I also placed a dot from my light dims LED dimmer on the four holes where the lips should be screwed in. With the C screw tighten the desk is very stable with no movements at all and the wheels at a 35 degree angle to the desk allows me to pull or push the desk around the 360 degree pole axis rather than pulling or pushing the desk on its wheels which is bumpy as the desk crosses the chair mat. BTW there are no wheel locks. I'll have to repeat that with the C-screw tightened the desk is as solid as my side table of which I am really pleased. As a bachelor this is also my supper table and the needed space at the upper part of my table is reserved for my keyboard of where I transpose the keyboard to and replaced with a plate full of food and without the C-screw I was always fearful that the tabletop would swivel. So with all this said, my rating now goes up to 5 stars and as someone has said, this is a very adaptable desk. Plus as I said on my original review, it is the ONLY mobile desk that has the lowest height of 22" which is important if you use an Armchair for your pilot seat for your computers. Highly recommended mobile desk! Very Stable, Very Mobile, Very low 22" and better than any other mobile desk or over your bed desks out on the market! Highly recommended.Back to my Original review: Now the main reason that I bought this mobile desk is that it has the lowest height of all the mobile desks on Amazon; 22" which is the heigh of my armchair. My monitor is the 65" 4k HDR TV. I have been using an ikea side table for my mobile desk for quite a while now and it will take some time to adapt to this new desk but the first thing that I notice is when I push my desk away by pushing on the table top is that the desk rotates instead of being pushed away. No matter how much I tighten the knob for height, the top rotates 360 around the single pipe leg. The cup holder isn't big enough for my phone so I put a phone holder into the cup and of course the cup holder wobbles so you can angle the desk and the cup stays upright. It is wobbly enough that my phone isn't quite safe... yes yes I am just whining. Alright the pros is that the whole desk is very light weight since it is probably made of aluminum. The construction is amazing as each piece is made especially for the design of this desk. Every screw is labeled in individual zip lock (almost impossible to open) bags with tiny letters "A", "B", "C" and so on that correspond to the instruction 2-sheet paper. I cannot find where to use the "c" screw. Well constructed. Now I just need to stop the cup holder from wobbling like a ship and dumping out my phone and stop the desk from rotating. Duck tape will probably work for both instances. OK fine, I'll give it a rating of 5 stars but the swiveling of the table still annoys me when I push it away... perhaps that is what the "c" screw is for?

Si quieres escribir en la cama no lo recomiendo porque tienes que estar sentada en la orilla, totalmente pacífica al borde.

Esta mesa es buena en general, mientras no necesites ponerla alta, si la pones alta no pongas nada de valor en ella porque con el tiempo se aflojara y terminara callendose. Pesima mesa.

legó MUY rápido (Jueves en vez del Domingo). Fácil de armar, muy bonita. Ideal para discapacitados que trabajan en cama. Lo recomiendo mucho. Excelente precio.

Well-made, sturdy and adaptable tray for wheelchair and cross-bed use

Assembly:Putting together wasn't terrible, but it wasn't fun. Pretty easy overall.Usage:First off, this laptop stand is really great for my use. I'm a developer/designer. I get back and neck pain that lead to a migraine when I work at a flat surface like a traditional desk so for me it was important to find a stand that I could angle. This gets a 5 star for angle options.It also needs to come close to me so the width apart of legs/wheels/feet are important in how they align with my office chair wheels. Past stands have been a pain to position just perfect with the chair. This one is 4.5 star in that area.Appearance was a huge bonus. I've looked at just about every stand on Amazon and other sites and why does almost every one of them need to look like wood. Personally, I hate fake woodgrain. Why not just be what you are, crappy laminated particle board.Right next to appearance is the material. I like metal things. I use magnets a lot for doing all sorts of things. Another benifit of metal for me personally is Humidity as I use this on my Balcony so laminated particle board stands eventually start getting bubbly and will obsorb anything inlcuding condensation from a drink.The wheels I was worried about. I thought they might be too small. They do ok but if you plan to use on carpet this might not roll so well. I haven't tried tho so I could be wrong.The little basket was originally something I didn't want, but actually it was a nice little addition with its gimbal to rotate. That rim of the cup was originally a tiny bit to big to allow it to tilt as far as I had my table top angled so I fixed that by squeezing it a little. Minor oversight on their end I suppose.Now on to the things I did to make it better! (for my personal use anyways)I hacked an alternative to the dont-fall-off-bar. My laptop is thinner than that so it was uncomfortable on my wrists. I replaced that with those little grippy rubber cable ties cut in half, folded and shoved in the holes. this is just enough to keep my Mac from sliding off.I also added a couple adhesive disks for couple suction cup mounts. Can see those in the pics. Another little addition was a power strip and kitchen stand and the magnetic spine off some old iPad Smart Covers used to hold prevent other small items from sliding off.I plan to make more modifications as I work with it to see how I can perfect comfort mixed with practical use.So far no problems handling the weight of my arms or anything like that. I really like this thing.