No hay artículos en el carro
No hay artículos en el carroMás información del producto
Mike G.
Comentado en los Estados Unidos el 18 de marzo de 2025
Makes the installation of inserts much easier.
JR
Comentado en los Estados Unidos el 16 de mayo de 2024
I love these EZ Lok drivers. The tool drives the threaded insert to a proper depth and disengages automatically. This is much better than using a screwdriver (you have to be careful to get the depth right) - especially when using a power driver. Makes the work quick and accurate.But it is important to use the propper size driver for the insert you are using - that why I bought three of these in different sizes.
Marie Wagner
Comentado en Canadá el 18 de diciembre de 2022
dhbcifuoev0
Comentado en Canadá el 21 de enero de 2021
Makes installation of the threaded inserts much easier.
George N. Lawrence
Comentado en los Estados Unidos el 29 de julio de 2020
Although only the E-Z Lok numbers are mentioned, I found this 500-5 to work very well with the Hellman 3021 3/8-16 brass threaded insert. Note there are tabs on either side of the 500-5 that have to fit into the slots of the insert. The slots of many threaded inserts are too narrow for these tabs. But slots of the Hellman 3021 are wide and work very well. Assuming you are wiling to lay out about $2 per 3/8 insert, the Hillman is, in my opinion, the strongest insert and is great for both soft wood and hard wood. The 3/8 inch Hillman is almost an inch in length and should have a higher pull-out force in soft wood than shorter inserts and also work fine in hard wood (if you have the length available). An additional advantage is that brass inserts have noticeably less friction than steel inserts.I can drive the 500-5 straight using my impact drill and can extract the insert with the same tool provided I keep firm downward pressure.The only limitation to this 500-5 is its OD is larger than the 15/32 inch hole Hillman recommends and I have to stop when the insert is flush.I like to drive the Hillman insert a bit below flush for optimum strength. The T-handle hand tool that Hillman sells for about $7 has an OD smaller than 15/32 and can drive the insert below flush with a turn or two at the end and extract a sub-flush insert back to flush with the same tool. My impact drill with the 500-5 can start up and finish the job outside of flush.I also bought the 500-4 which works well with the 5/16 inch Hillman inserts, but the 5/16 inch Hillman is a lot shorter than the 3/8 Hillman so I kept to the 3/8 inch Hillman and coughed up the money.
Productos recomendados
Mex $502.00
Mex $ 245 .00 Mex $245.00
Mex $289.51
Mex $ 136 .00 Mex $136.00
Mex $298.00
Mex $ 140 .00 Mex $140.00
Mex $600.00
Mex $ 306 .00 Mex $306.00
Mex $468.59
Mex $ 248 .00 Mex $248.00
Mex $252.14
Mex $ 141 .00 Mex $141.00
Mex $231.42
Mex $ 122 .00 Mex $122.00