No hay artículos en el carro
No hay artículos en el carroEl termostato Emerson NP110 de una etapa no programable es compatible con sistemas de calefacción, refrigeración y bomba de calor de una sola etapa (sin auxilios). Este termostato cuenta con visualización retroiluminada y control preciso de temperatura de plus/menos -60 °F. *No es compatible con calefacción eléctrica de zócalo y algunos otros sistemas.
Tom Hill
Comentado en Canadá el 8 de febrero de 2023
This is a very basic unit with no temp offset, setbacks or scheduling capabilitiesNote that this is factory set in °F but can be mechanically modified to show °C
NIck
Comentado en Canadá el 26 de octubre de 2022
I purchased this thermostat in December 2021 to replace the original thermostat that came with my travel trailer. The original was Coleman Mach. See picture.After replacing it, the Emerson worked excellent. I can adjust the temperature degree by degree and is controlling it very good. It is a great product and worked excellent for my application.
CB
Comentado en los Estados Unidos el 11 de junio de 2020
This was exactly what I was looking for. The display shows you the temperature of the room and what the set temperature is. Some people had commented that you can't see it, but you definitely can read this display very well. I personally don't care for setting multiple temperatures, this lets you set the temperature and forget about it. You can easily adjust by pressing the up or down button to change the setting. I had my heating and air guy install it while he was doing my bi yearly maintenance check on my systems. It was a quick install. It is accurate. Very readable. I would highly recommend this thermostat.
joseph
Comentado en los Estados Unidos el 5 de noviembre de 2020
The wire terminals could be better positioned. The most logical way to route the wires would place them behind the temperature buttons - the ones you use are not part of the face, they must contact the actual buttons attached on the circuit board. It may be easier if you have only one thermostat cable, and not two (the air handler installer opted to add another cable rather than replacing the existing one). It was a simple install, other than the wire routing. The labels were helpful to mark the wires being used. I have found I do not need the backlight - all the settings seem to be easy to read. I would prefer that it not need a battery, but many models do. I was looking for an inexpensive replacement to our old, erratic mercury switch thermostat. I have found it to be reliable and accurate so far. It does audibly 'click' when operating, but so do many others - have not found the noise problematic. Other household items make noises as well. This thermostat displays both the set and current temperature at the same time. It also displays the current temperature when it is off. The cycle is not fine-tuneable (there is only one permanent modification available, meant for hydronic), but I have found it to cycle the system acceptably.
Ron Mc.
Comentado en Canadá el 13 de octubre de 2020
Technically it is not complicated to install, but the terminal strip is small and there is not much space to route the wires, making a bit challenging to get the typical rigid 18-gauge solid wires connected properly. You will need a Phillips size 0 screwdriver to fasten the wires in the terminal strip.There is a backlight, but requires a procedure using the up/down controls to enable it.The two required AAA batteries ARE included.Defaults to degrees F, can switch to degrees C by cutting a jumper wire on the PCB.
Productos recomendados
Mex $954.00
Mex $ 477 .00 Mex $477.00
Mex $3,397.03
Mex $ 1,460 .00 Mex $1,460.00
Mex $2,320.00
Mex $ 1,044 .00 Mex $1,044.00
Mex $3,328.62
Mex $ 1,664 .00 Mex $1,664.00