No hay artículos en el carro
No hay artículos en el carroEste tornillo de arranque está diseñado para que coincida con el ajuste y la función de la pieza original en vehículos especificados. Hecho de materiales de calidad, está diseñado para un rendimiento confiable.
bargin hunter
Comentado en los Estados Unidos el 7 de octubre de 2024
If you are replacing a GM starter with a newer style induction/reduction gear starter, they usually have a smaller body and mounting flange from the original. Using the old bolts typically will not work because the old bolts are too long by about 5/16". This bolt mimics the original bolt, but is just shorter by 5/16". I prefer this style rather than using a shorter standard threaded bolt because the original bolt is a little larger in diameter on the upper 90% and then has a slight taper to where the threads start at the bottom. The second flange on the starter where the bolt goes through to attach to the engine block, is slightly smaller in diameter so that it helps center the starter when you install it. Some mechanics had suggested using a stack of washers next to the bolt head to make up the 5/16" difference, but this also makes it more likely to loosen up over time. This is a much better solution. It is also the same hardness rating, supposedly, as the original bolts. Do understand, this is a box of 20, not 2.
joseph$
Comentado en los Estados Unidos el 9 de agosto de 2021
Great product
motorcityreman
Comentado en los Estados Unidos el 30 de julio de 2021
Perfect
Productos recomendados
Mex $613.00
Mex $ 300 .00 Mex $300.00
Dorman 610 - 401 M12 - 1,50 tornillo de la rueda - 17 mm hexagonal, longitud de 25.3 mm (caja de 10)
Mex $516.46
Mex $ 237 .00 Mex $237.00
Mex $729.89
Mex $ 350 .00 Mex $350.00