No hay artículos en el carro
No hay artículos en el carroHicksville SDA Church
Comentado en los Estados Unidos el 12 de febrero de 2025
The capacitors were perfect for the job. Thanks
VsK
Comentado en los Estados Unidos el 7 de julio de 2024
Exactly as described and working perfectly for months now. Great value as a 2 pack.
Ivan
Comentado en los Estados Unidos el 24 de julio de 2024
Installed and fans run beautifully now.
Hen
Comentado en los Estados Unidos el 25 de febrero de 2024
No screw tab to anchor it down so I just siliconed them to the old capacitors :-;Seems a little weak for these desktop fans. I wish I had gone up to 3.5uF instead of the 2.5uF I boughtI was surprised that one fan had a 2,5uF cap and the other fan with the smaller blades has a 3.5uF cap in it
Jerónimo
Comentado en los Estados Unidos el 5 de noviembre de 2024
I'm gonna test it in my ender 3, just ordered the wrong one but maybe it will work with the ender 3.
Gypsylady1024
Comentado en los Estados Unidos el 4 de noviembre de 2024
nice parts as good as new after install
Gary & Nancy
Comentado en los Estados Unidos el 18 de noviembre de 2024
Official Creality sealed packaging.I acquired this as a spare for my Ender 3 printer.From all appearances it is the real thing from manufacturer.
michaelcrossland
Comentado en los Estados Unidos el 28 de octubre de 2024
So far I have no issues with the belt it does fit my printer a Ender 3 V3 SE just fine. Just as a side note you can use one them on both the Y and X on the printer the only one you can't use it for is the top Z belt. Other then that it It nice and stoung and it does fit, I have tested that much but I have not put it in to use yet because the belts that come with my printer is still in good shape but the x one is looking like it may need to be changed out sooner then later. Will worth getting few them on hand if you do any kind of 3D Printing and have the printers that they are made for.
Stew
Comentado en los Estados Unidos el 15 de octubre de 2024
Anyone who uses bedslinger cartesian 3D printers knows that over time, the Y axis belt will stretch or break due to the weight of the bed and the repetive motion. Although it's possible to make your own belts from 6mm wide GT2 timing belts, there's a lot to be said for having them premade of the correct length and with crimps already done for you. There is some disassembly needed to replace this belt on the Creality Ender 3 V3 SE. However, Creality has a detailed video showing the process on this particular printer. For the low cost, this is a good investment to make if it means getting your printer back in operation quickly.
terrymish
Comentado en los Estados Unidos el 25 de septiembre de 2023
My ceiling fan was gradually starting to run more and more slowly, and noisy, especially on the low speed. I replaced the capacitor over 3 years ago with this Podoy CBB61. The fan is on our back deck, so it gets major temperature/humidity extremes. Now after 3 years in the the fan is starting to run slow again, so I've had to replace the capacitor again. It takes very little time, and is very inexpensive.
Productos recomendados
ANYCUBIC FEP Film 2 piezas para fotón overol 2/fotón overol 4, diseño integrado, fácil de reemplazar
Mex $448.60
Mex $ 219 .00 Mex $219.00
Mex $164.00
Mex $ 96 .00 Mex $96.00