No hay artículos en el carro
No hay artículos en el carro
Descripción
1. Algunas fotos parecen un tamaño más grande, ten en cuenta el tamaño exacto de los artículos.
2. Nota:
1 cm = 0.35 pulgadas, 1 pulgada = 2.54 cm, por favor permita un error de 1 a 2 cm. gracias!
3. El paquete incluye:
1 juego (adaptador de 2 piezas y tornillos4 piezas)
John Zucco
Comentado en los Estados Unidos el 26 de junio de 2024
Just note you need a 9volt power source (not battery) but works great and has a light too. I have a latching Boss but not a fan of operating on batteries.
Michael R. Vaccaro
Comentado en los Estados Unidos el 15 de mayo de 2024
I needed to mount a switching power supply to a din rail. This worked perfectly to adapt the power supply to din rail mounting.
Simone
Comentado en Italia el 26 de julio de 2023
utilissimo. l'unica pecca è che si accende il Led quando uso il canale pulito sul Marshall, si spegne sul canale distorto. Poi ho notato una cosa strana: se lo collego all'ampli con il suo cavo in dotazione il Led si accende anche se non alimento il pedale. Beh tanto meglio
Rick Jones
Comentado en el Reino Unido el 6 de febrero de 2023
I’ve got two of these. They’re smaller than the footswitches that come with most amps, so they aren’t as obtrusive on a pedalboard.When run with my Cornford, the LED status indicator works even if not plugged into the 9v power. However if you do use the power supply socket, it’s brighter.The feet come off easily and if you apply Velcro to the entire base they don’t move on your pedal board even if you accidentally kick them.Sockets are robust, switches are good. I used one as a tap tempo with a Keeley delay station for a few weeks until a non-latching switch showed up.Should last years even with regular use.
The Graffs
Comentado en los Estados Unidos el 26 de febrero de 2023
I tend to make a lot of one-off PCB mounting to DIN rails for various projects, and these allow me to make a simple 3d printed base, and mount anything.One star removed because the mounts have three holes each (6 per pair) but they only provide 5 screws. Sure, I could usually use 2... but there are 3 holes...
Maurizio
Comentado en Italia el 4 de abril de 2022
È un buon pedale, robusto e per quanto vale fa il suo lavoro. Strano che con la mia testata fender bassman la luce sia spenta con l’overdrive e accesa con il clean. Mi sarei aspettato l’opposto
Lolo
Comentado en los Estados Unidos el 8 de febrero de 2020
Simple part does what it's supposed to
Customer
Comentado en los Estados Unidos el 19 de noviembre de 2020
I cannot complain at all, good workmanship and does what it is meant to do.
Kharl
Comentado en Alemania el 11 de junio de 2019
Top
Justin T.
Comentado en los Estados Unidos el 8 de octubre de 2018
Good for the price
Productos recomendados