No hay artículos en el carro
No hay artículos en el carroMaWilli
Comentado en los Estados Unidos el 24 de enero de 2025
Sharp and the shaft was straight. I mounted this in a palm router and it is chewing an end grain cutting board nice and flat! So far has cut through Zebra wood, Purpleheart, Padauk and Okoume with no problems.
Mauricio Mellado
Comentado en México el 16 de marzo de 2024
Cumplió el objetivo para lo que la compre, en madera de pino el filón se sintió como cuchillo en mantequilla, en madera de encino me sorprendio, me hubiera gustado que su tamaño de largo fura de al menos 6 o 7cm ya que montada en el router apenas si logre la profundidad buscada, aun así logre sacar adelante el proyecto!!
Customer
Comentado en México el 22 de febrero de 2024
ok
Brian Beahan
Comentado en los Estados Unidos el 18 de diciembre de 2024
I was able to plane three sides of an eight foot by ~7" wide railroad tie with this bit, my router and a router sled/jig I made. Honestly, I thought I was going to wear this bit out because it's a really hard piece of oak. This was my first time to plane anything and this bit and setup worked perfectly. Can't believe it. Also - couldn't find a surfacing router bit at my home depot, so I am glad I was able to find this at Amazon. I would buy this again if I needed it. Mine still works fine, so I will use it in the future should the need arise.
Claude
Comentado en Canadá el 7 de noviembre de 2024
Created a flattening table and used this bit. Worked with ease on a huge maple slab with epoxy poured in certain areas. Did the job with ease and still working it without issue.
Flavio rosales lopez
Comentado en México el 17 de enero de 2024
El tamaño ,es adecuado...
R. Thompson
Comentado en Canadá el 10 de septiembre de 2024
But if it is for a large project, consider a larger size.
Value for money
Comentado en Canadá el 30 de abril de 2024
I am a hobbyist woodworker operating from garage. I do not have a jointer and planer since these are expensive tools. I saw a you tube video on making a simple jig and with the use of a router and this surfacing bit, I was able to plane the surface for my projects.So far so good and happy to recommend this bit to others.
Medina
Comentado en México el 8 de agosto de 2023
Excelente para emparejar madera buen desempeño sobre madera dura
Eduardo
Comentado en México el 27 de marzo de 2023
La estoy utilizando para realizar jaladeras en hojas de mdf enchapadas con melamina
Juan
Comentado en México el 8 de octubre de 2023
Me parece que funciona bien aunque para mi gusto pierde filo al poco tiempo
Ovidio Calvet
Comentado en México el 24 de junio de 2022
Perfecto para rectificar maderas en el cnc
Beto Mora
Comentado en México el 12 de agosto de 2021
Aunque la descripción del producto es clara e indica medidas, me la imagine mas grande, la fresa apenas es del tamaño de mi dedo indice y el ancho de corte es exactamente el mencionado. Considero que vale la pena el precio porque te incluye el adaptador del collet, asi que si tienes otras fresas de 1/4” el adaptador te servira para utilizarlo en otro router con collet de 1/2”.Aun no la uso pero espero buen desempeño
Productos recomendados