No hay artículos en el carro
No hay artículos en el carroEste manómetro de prueba de presión y conjunto del cuerpo de la válvula está diseñado para medir la presión en la tubería de gas o el tanque. Tamaño de la esfera: 2 cm. Conexión: 3/4" NPT hembra, cuerpo de prueba de gas en acero chapado en cromo. Caja de acero negro y bisel Bourdon. Tubo de aleación de cobre. Esfera y puntero: aluminio, negro. Ventana: vidrio precisión: +/-3-2-3%. Temperatura de trabajo: -4 a 140 F/ -20 a 60 C. Tamaño de la esfera: 2 cm. Conexión: 3/4" NPT hembra, cuerpo de prueba de gas en acero chapado en cromo. Tubo de don : esfera de aleación de cobre y puntero: aluminio, negro. Ventana: vidrio interior de partes mojadas: latón/aleación de cobre. Precisión: +/-3-2-3% Temperatura de trabajo: -4 a 140 grados F/-20 a 60 °C.
Matthew D Bergum
Comentado en los Estados Unidos el 2 de febrero de 2025
I installed this on my black pipe and added 15 lbs of air. The system shows that It held the pressure after i checked in several days. I released the pressure slowly thru a valve down stream, then removed the guage to use on another line I needed to test. Unfortunately the guage now shows around 18 lbs even before I add air. I tried adding air and releasing it but it never goes below 18. I can't see where there is an adjustment...and of course the 30 day return window was 2 days ago...so it appears I'm stuck with this broken guage.
Michael Roche
Comentado en los Estados Unidos el 14 de enero de 2025
Not me ch to say it worked
Harrius
Comentado en los Estados Unidos el 11 de septiembre de 2024
Bit loose on threads, Pipe tape worked to seal- could be tighter tolerances but worked.
Weber Lau
Comentado en los Estados Unidos el 8 de diciembre de 2023
The gauge assembly is solidly made, and didn't leak anywhere. It came with a metal bleeder/cap, not the black plastic cap shown in the illustration. If you mount it in a fixed position, you would not notice, that the reading fluctuates about the width of the pointer tip depending on the orientation of the gauge. I found that if held 90 degrees CCW from horizontal, the gauge reading would increase, and if held 90 degrees CW from horizontal, the gauge reading would decrease. For portable usage such as checking for leaks, remember to take each reading with the gauge in the same orientation.
Wahali
Comentado en los Estados Unidos el 16 de noviembre de 2023
For the price it's an excellent tool. Maybe just for a one time job or more. I can't speak to the longevity but it appears well made. I figure a long as you take care of it it'll last. I ran a csst line in combination with black pipe stub out. I used a handheld air compressor to get it to 10 psi. It held for over 15 min. Propane company came out and hooked me up. This helped to insure the job was done right and safe
Productos recomendados
Mex $508.90
Mex $ 254 .00 Mex $254.00
Mex $2,789.00
Mex $ 1,282 .00 Mex $1,282.00