No hay artículos en el carro
No hay artículos en el carroDescripción del producto
Detalles del producto:
jose n.
Comentado en México el 18 de octubre de 2022
Intente hacer prender e hice varios arreglos y ninguno prendio
Juan G.
Comentado en México el 17 de septiembre de 2022
Buena calidadPequeños pero muy luminosos
MTPJ Jegerings
Comentado en los Países Bajos el 19 de abril de 2022
Many of the LEDs are broken. 60 %. Luckely I only needed a few.
Derek P.
Comentado en el Reino Unido el 30 de mayo de 2021
Place these anywhere and just run the 3 wires in and out great for different effects
Mattia Z.
Comentado en Italia el 20 de enero de 2020
Prodotto di nuona fatturra, qualche led ha problemi di in/out(ma su 100) non è un grosso problema.Fanno una luce molto intensa nella foto ho le finestre aperte ed entra luce eppure sembra buio con questi led.I led sono SINGOLI devono essere saldati, non sono strisce led.Funzionano perfettamente con la libreria adafruit neopixel in Arduino IDE.Io gli consiglio, sono ben fatti e funzionano perfettamente. Ottimo rapporto qualità prezzo.
Customer
Comentado en Canadá el 18 de octubre de 2019
Awesome lights for projects requiring custom LED work. Small little buggers to solder though! Six solders per led is a lot, so hopefully you don’t require too many for each of your projects. Awesome with using FAST LED Arduino library and an ESP8266 board. Happy DIY’ing!!!
Michael L V
Comentado en los Estados Unidos el 26 de noviembre de 2017
These are fantastic! They are small, about the size of a penny, so they require some dexterity to work with. I use a helping hand to hold them for soldering though and it is no problem. They work brilliantly! I have driven them so far using a Raspberry Pi 3, an Arduino Uno and a Nano. In all three cases they were great, bright, nice color and very responsive. I bought a 5v 15amp power supply to power them, but I have also plugged them directly into the 5v rail of my EVGA G2 1300 watt psu as well and they worked no problem. Keep in mind that all 100 of these at full brightness will draw a lot of amps, way too much for your USB port, so a power supply is a must.Soldering is pretty easy. They are small, but the pads are ample enough, there are 6 total, 2 for 5v, 2 for ground and 2 for data in and out. That is 600 solder points for the whole lot! I have had the best success using single strand 20 AWG hookup wire. I tried some stranded 4 pin wire I had for regular rgb led's, but it became brittle and snapped off at the solder points when handled too much. I picked up some 18 AWG 3 pin cable as well, but it is stranded cable and can be a pain to solder. SIngle strand cable has been the easiest for me by far. I am enjoying these a lot and will be buying lot's more!
Productos recomendados
Mex $298.00
Mex $ 157 .00 Mex $157.00