No hay artículos en el carro
No hay artículos en el carroZezhile Hansen
Comentado en los Estados Unidos el 16 de marzo de 2025
I keep saying these things are so expensive, but continue to hear they are worth it.I purchased the Bilstein Steering stabilizer for my Ford Excursion. It seems to be doing a good job for the past week. All the other brands I have tried in the past always end up leaking after a year.Some of the reviews for this stabilizer complain that it's is pressurized and causes there vehicle to drift to the left.It is pressurized coming out of the box. For my application, this made no difference in where the truck wanted to go. Straight down the road with no problems.I have passed over the Bilstein in the past for my vehicles just due to the cost.A few months ago I installed front and rear on a Ford Ranger, they made such a difference on that little truck.When my Ford Excursion needed new shocks the Bilsteins were contenders. The cost is high, but the performance is worth it.Keeping a 9500lb. vehicle in check is a quite a chore for any shock.If your on the fence, get this brand.
Jason R.
Comentado en Canadá el 1 de marzo de 2022
2000 f350. Made it whole new truck to drive. Front end was tight but still wandered around. This made it a whole lot better.
Katelyn
Comentado en los Estados Unidos el 22 de diciembre de 2022
Super easy to install. Comes with instructions including what length your bracket has to be at for it to fit appropriately. Stock bracket is required. Be SURE to measure from the right spot! I have attached a picture. In the instructions I don't think the picture is quite clear enough and it may seem like you measure from the dimple closest to the passenger tire. Don't do that. Measure from where my picture shows. If you install and are getting popping noises when turning your measurement for the bracket is off. I made the mistake so you don't have to!My clevis was bent and wouldn't allow the new stabalizer to even begin to seat in there. Pair of vice grips and a really big bar allowed me to open the clevis up enough to get the new stabalizer end in there. Picture attached with how I did that if you happen to run into the same issue.
TRAVISW HIGGINS
Comentado en Canadá el 16 de agosto de 2019
I ordered this to replace the same damper that was already on my '04 F350 while troubleshooting some issues. Ended up the damper on the truck was still in good working order. I don't know when it was installed but it looked like it had been on there for quite a while, so it must be a well made part!
Declan Dinnadge
Comentado en Canadá el 17 de enero de 2018
Bought this for my 2001 f350 7.3l along with the Rancho RS5542 Steering Stabilizer Bracket Kit because my truck for some reason did not have a bracket. Truck steering was super sloppy thought about buying a new steering box bit thought I would try this first, and wow noticeable truck doesn't wonder anymore and no bump steer love it. Would recommend
Productos recomendados