No hay artículos en el carro
No hay artículos en el carroSoporte de radio construido y moldeado a partir de la exclusiva construcción AccuMold de Bianchi con exterior de tela balístico y forro de Coptex.
joe
Comentado en los Estados Unidos el 27 de julio de 2023
Holds my radios just fine. Fits well and stays secure.
Jorge Sánchez
Comentado en México el 1 de mayo de 2021
Con unos ajustes quedó bien para un radio tph900. Tiene buena estructura que lo mantiene bien asegurado.
David
Comentado en los Estados Unidos el 23 de marzo de 2019
The holster is adjustable and secures the radio well. Does not hang low and is comfortable while sitting in your unit. No problems with the belt fasteners coming unbuttoned.
Jonathan F.
Comentado en los Estados Unidos el 11 de enero de 2019
Okay, so I am going to be honest here. I have been issued this type of radio holder since 2006. This is one of the best non-swivel radio holders that is available on the market. BUT YOU GOTTA KNOW HOW TO PUT IT ON YOUR BELT! Because it's a pain if you dont. I would recommend you dont undo the snaps. Just take the buckle off your belt and slide it through. Because the snaps are the "lift the spot" type of snaps. And if you unsnap them and put the holder on your belt, its almost impossible to get the right angle to get them to lock. You will get a "false lock" and when significant force is applied, the snaps will come undone. If you see any crome or silver from the snap fasteners (center picture), you havent put the snaps back properly.I have included pictures of the basketweave version of this holder for reference.
Customer
Comentado en Canadá el 29 de noviembre de 2018
Had to replace my last radio holster. This one is excellant, takes up less room on my duty belt, can actually get my hand in my pocket without haveing to adjust my radio position.
walt c
Comentado en los Estados Unidos el 7 de julio de 2015
Durable and holds the rover in place. You will have to use the strap.
Productos recomendados