Yes I never heard of this brand either. But works just as well as Genie, or Lift Master. All the same features very pleasantly surprised. Bought it for one of my rental properties but would use on my own house in the future. It was less expensive to install this new unit than to have my old lift master serviced and buy a new circuit board. 3/4 hp is 1/4 hp stronger than my old unit and more than $60.00 less than a new 1/2hp name brand with same warranty. In addition you can return this unit where you couldn't return the name brand units. Instructions were simple and straight forward took me an hour but that also included removing my old unit.

I have had this garage door opener for about a year now and everything is still working good. It’s pretty quiet compared to the previous one that I had. Set up was fairly easy. I am happy with my purchase.

No se pudo cargar el contenido.

Lo instalé personalmente, funciona, me gusta, la luz es mejor que otros. No tiene batería de respaldo. Intenté instalar el auxiliar wifi pero jamás pude.

No se pudo cargar el contenido.

Exelente producto trae una lámpara fabulosa que aluza perfecto la cochera y lo más importante y exelente es el sistema de cerramiento r apertura de la puerta no golpea nada lo tengo en mi cochera y si tuviera otra casa lo compraría cerrado de ojos los felicito llegó antes de la fecha y su precio ni que decir gracias enorahuena es un súper producto

Lo instale en donde previamente había otro y eso facilitó todo . La polea funciona muy bien y el motor con buen poder , la programación es sencilla y los sensores de seguridad bien .Se puede abrir con una aplicación desde el celular y los controles de puerta que se programan muy fácil . No lo he probado con Alexa con lo que se supone que también funciona.De los que e tenido este es el mejor .

I bought three of these to replace two aging garage door openers (and one garage that doesn't have one). They're easy to install and get them functioning - it took me approximately 3 hours to install two and route wires correctly. I've been using two of them for just over two months now.They're quiet, consistent and the lighting is great! The motion sensor works well - I had one incident where one didn't turn off - I unplugged the unit and plugged it back in and it's been fine since that one time.What I don't like? The garage door "Smart Controller" - you program it using their app and it sends light pulses to program the unit. This programming is wildly unreliable. I programmed one unit successfully after several attempts (more than 5) - following the directions in excruciating detail. The second unit refuses to pair at all - I've tried more than 10x and get the same blinking red light of failure. I have VERY strong WiFi in my house and I'm using the recommended 2.4Ghz band.I'm going to buy another company's controller and toss this brand's controller in the electronics recycling bin.

I am a very handy guy and have worked on cars and houses most of my adolescent and adult life so I was not afraid to tackle putting up a new garage door opener when my old one finally died. I did my research, looked for one that work work in a modern, automated home, and settled on the Beam BU800 Centurion. I picked the model because of its features, motor sized, linkage type, price, and customer reviews. This one checked all the boxes. I ordered it and promptly let it sit in the box in my garage for the next six months! LOL!When I finally got around to putting it up, it was easy to put together and the instructions were pretty easy to follow. I was able to use my old garage door openers ceiling bracket, garage door bracket, and track bracket over the garage door. I had the new Beam BU800 up in less than an hour. I followed the programming guide and set both my upper and lower limits and the automatic force programming worked just fine.I then did a test run and the garage door opened smoothly and with out issue. However, when I went to close the garage door, it would only move it about three inches and then stop and sound a series of warning beeps (20 to be exact). I tried it again with the same results. I reprogrammed it and tried again, same results. At this point, I decided to contact Beam Support. I quickly video the opening and attempted closing of the garage door, attached it to an e-mail and set it Beam support on a Sunday night around 8:30 PM. The next morning I had a phone call from Beam support and I walked the engineer through the issue. They had me check the beams, then they had me over ride the automatically learned force setting to apply more downward force. This did not fix the issue. They asked that I make sure that there was no binding with the rollers, they were properly oiled, and that the tension on the torsion spring was set right. Instead of me messing with the torsion spring (for those who don't know, they are very dangers and can severely hurt you if you are not careful) I called my local garage door company (who installed the garage door when we build the house) and they came out made some adjustments (because it was a little stiff) and even helped me "troubleshoot" the opener. They agreed that it had to be something with the garage door opener itself.I contact Beam Support again and this time they said they were shipping me out a new logic board to replace the one in the BU800. It got here yesterday and before it had even been delivered, Beam support reached out and asked if I had received the part and if I needed their help to install it. I did not have the part yet and did not know it would be delivered later in the day. When it did come, I e-mail Beam Support to let them know it was here and asked them how they wanted me to replace it. They sent detailed instruction on what to do. It took me about 15 minutes to remove the old logic board and replace it with the new logic board.After it was replaced, and before I put the engine housing back together, I programmed the up and down limits and the force and ran a test cycle. VIOLA! It worked just like I expected it to!!! I ran probably close to 10 additional cycles just to make sure it did not have any issues. It worked every time just like it should.I know may of you will read this and say "it should have work out of the box" and while that may be true, you never know how something was handled at the warehouse or in shipping so I cannot fault them for it not working. What I can do is praise them for having fantastic customer service and never ignoring my requests for help. They were Johnny-On-The-Spot and helped me get it working as advertised!The product is much quieter than my old chain driven open, works with my home automation system and has all the features I am looking for. I would highly recommend this product and this company to anyone who is looking for a good, powerful, quiet, product that comes from a company that will stand behind its product!And no, I was not paid to write this nor did I get a "sample" product to review. I purchased this with my own hard earned money and I am will say it was worth every penny!